How do you remove the rear bumper on a Hyundai Santa Fe?

How do you remove the rear bumper on a Hyundai Santa Fe?

Loosen the mounting bolts. Disconnect the rear bumper main connector (A). After loosening the rear bumper side’s mounting screws, then disconnect the side’s. Loosen the rear bumper upper mounting clip.

How do you remove a bumper cover?

Pull the plastic shield down out of the way if it doesn’t come off completely. Reach behind the bumper at each corner and you should find a bolt holding the corner of the bumper to the car. Remove these bolts. The bumper should come off.

How do you take the back bumper off a Hyundai Tucson?

Hyundai Tucson: Bumper / Rear Bumper Repair procedures

1. After loosening the mounting screws, then remove the rear combination lamp (A).
2. Push the lock pin, disconnect the connector (A).
3. After loosening the rear bumper side’s mounting screw and clips, then disconnect the side’s.
4. Loosen the mounting bolts.

How do you change the front bumper on a Hyundai Tucson?

Hyundai Tucson: Bumper / Front Bumper Repair procedures

1. Loosen the radiator upper cover mounting bolts and clips.
2. Remove the mounting clips.
3. After loosening the front bumper side’s mounting screw and clip, then disconnect the side’s.
4. Push the lock pin, disconnect the fog lamp connector (A).
5. Remove the front bumper.

How do you remove a Creta tail light?

Outside light

1. Open the tailgate.
2. Loosen the light assembly retaining screws with a cross-tip screwdriver.
3. Remove the rear combination light assembly from the body of the vehicle.
4. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.

How do you change a brake light on a Hyundai Tucson?

Pull Out Old Light Bulb Rotate the small grey bulb socket 1/4 turn in the counterclockwise direction before pulling it straight out of the housing. Pull the old reverse light bulb straight out of the socket and push in a new number 921 (or W16W).

What is the difference between 2057 and 1157?

The main difference between the 1157 taillight bulb and the 2057 is that the 2057 draws about 30% less current when using the running lights. They are interchangeable like you mentioned.

What is the difference between a 1157 and a 2357 bulb?

The high filament of the 2357 bulb is rated at 2.23 amps vs. 2.10 amps for the 1157, so there’s not a big difference there. The low filaments have the same life expectancy rating at 5000 hours, but the high filament of the 2357 bulb is much shorter than that of the 1157, with the 2357 rated at 400 hours vs.