How do you replace a rear end seal?

How do you replace a rear end seal?

To replace the seal, take the following steps:

1. Jack up one side of your truck to take the weight off the wheel.
2. Remove the wheel.
3. Remove the axle shaft.
4. Remove the hub retaining hardware.
5. Slide off the hub and drum as a unit.
6. Replace the seal behind the hub.
7. Put everything back together in the reverse order of removal.

How do you remove a stuck pinion seal?

Just brace the bolt on the pinion and put the jaws on the seal and pop it out when you turn it! Take a look at the new seal. Then with a flat head screwdriver and hammer you’ll get it out.

How much does it cost to replace a rear pinion seal?

Pinion Seal Replacement Cost – RepairPal Estimate. The average cost for pinion seal replacement is between $229 and $273. Labor costs are estimated between $169 and $213 while parts are priced at $60. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.

How do I know if my pinion gear is bad?

How do I know if my ring and pinion is worn? A howl or whine during acceleration over a small or large speed range is usually caused by worn ring and pinion gears or improper gear set up. Rumbling or whirring at speeds over 20 mph can be caused by worn carrier bearings. The noise may change while turning.

How hard is it to replace a pinion seal?

Fortunately, replacing a pinion seal isn’t a difficult task and there are a variety of methods to successfully accomplish that. Pinion bearing damage can otherwise result, and that could ultimately require complete differential teardown.

What noise does a bad pinion bearing make?

A “whirring” noise while decelerating at any or all speeds is most likely caused by bad pinion bearings or loose pinion bearing preload. This condition is typically always diagnosed as a bad ring and Pinion gear.

How much does a rear differential cost to replace?

You can expect a rear differential replacement to cost up to $4,000.

How long can you drive with a bad rear differential?

After a rear differential fluid change, most vehicles will go 20,000 to 40,000 miles before it’s due again.

How do you tell if you blew your differential?

When the rear diff fails, one of two things can occur which will let you know it’s gone south: Noise: – When driving, you’ll be hearing a lot of noise from the rear, especially when going around a corner. It could start out by it having a lot of whining, with it continuing to get louder over time.