How do you reset the oil change light on a Jeep SRT?

How do you reset the oil change light on a Jeep SRT?

fully depress the accelerator pedal slowly three times within 5 seconds and the OIL LIFE is reset

1. fully depress the accelerator pedal slowly three times within 5 seconds and the OIL LIFE is reset.
2. Turn off the ignition, then start the engine normally and the light should be reset.

How do you clear the perform service on a Dodge Ram?

Press and release the brake pedal two times. Fully depress the accelerator pedal slowly two times within 10 seconds. Turn the ignition switch to the OFF/LOCK position. The message should now be erased.

Why does my RAM say perform service?

“PERFORM SERVICE” on a Cummins diesel means your crankcase filter needs to be changed.

How do you reset service required on Find dealer now?

rokinrubi

1. Turn the ignition switch to the ON position (Do not start engine).
2. Press and release the brake pedal two times.
3. Fully depress the accelerator pedal slowly two times within 10 seconds.
4. Turn the ignition switch to the OFF/LOCK position.

What is a CCV filter?

The crankcase breather filter, also called a crankcase vent filter (CCV), is part of a vehicles crankcase ventilation system. This filter is a part of the crankcase ventilation system in internal combustion engines of a relatively small number of vehicles including vintage/muscle cars, race cars, and motorcycles.

How do you reset the check engine light on a 2016 Dodge Ram 3500?

How to Reset the Dodge Ram 3500 Computer

1. Pop up the hood of your truck and hold it open with the rod.
2. Remove the negative cable clamp from the battery, taking care not to touch the positive side of the battery with it.
3. Let the vehicle sit for 30 minutes.
4. Put the key into the ignition and turn over the engine.

How do you reset the check engine light on a 2016 Dodge Ram?

How To Reset the Check Engine Light on a RAM 1500

1. Find your battery under the hood and disconnect the black/negative cable.
2. Wait 20 minutes for the power reserve to expire. The RAM 1500 check engine light should reset automatically during this time.
3. Now, just reconnect the black/negative cable.

How do I reset my exhaust service?

Registered

1. Turn the ignition switch to the ON position (Do not start engine).
2. Press and release the brake pedal two times.
3. Fully depress the accelerator pedal slowly two times.
4. Turn the ignition switch to the OFF position.