How do you reset the tire pressure sensor on a Chrysler 300?

How do you reset the tire pressure sensor on a Chrysler 300?

How Can I Reset the TPMS Light?

1. Drive your car at 50 mph for 10 minutes to reset the sensor.
2. Find a place to park and turn off your car completely.
3. Turn your key to the “On” position without turning the car back on.
4. Press the TPMS reset button and hold until the light blinks three times.
5. Release the button.

How do you reprogram a tire sensor on a Chrysler 300?

Relearn Procedure:

1. Inflate all tires to the pre ssure listed on the placard.
2. Turn ignition to the ON position with the engine OFF (not the A CC position).
3. Press and release the MENU butto n on the EVIC until the message “Retrain Tire Sensor‐No” is displayed.
4. Press the STEP button to select YES.

How do you clear the codes on a Chrysler 300?

Use a diagnostic scanner to clear the codes. Connect the scanner to the test port, also called the ALDL (Assembly Line Diagnostic Link) usually located under the dash (see Resources section). Turn the engine “On” and follow the prompts on the scanner to pull the engine codes. Select the option to clear them.

How do I get my Chrysler 300 out of theft mode?

Turn the ignition off, and remove the key. Within five seconds, insert the second key and turn to the ON position. You should hear a single chime after ten seconds, and the red theft dot will begin flashing. Turn the second key off and remove.

What does red light mean on Chrysler 300?

if the light is light solid red, it means that the WCM can’t read the SKIM in the key and you have an invalid key code error. this happens if the battery in the key is getting low, if the WCM didn’t read the key correctly more than (3 I think) times on a successful start, or if there is a problem with the WCM.

What causes a car alarm to stop working?

Here are 7 reasons why a car alarm goes off randomly: Low car battery charge or a dead battery. Corroded or rusty battery terminals. Broken key fob.