How do you reset the tire pressure sensor on a Hyundai Accent?

How do you reset the tire pressure sensor on a Hyundai Accent?

Hold the tire pressure monitor reset button until the TPMS light blinks three times, then release it. Start the car and allow 20 minutes to pass for the sensor to refresh. The TPMS reset button is usually located under the steering wheel. If you can’t find it, consult your owner’s manual.

What does it mean to calibrate tires?

Any time you inflate, change, or rotate one or more of the tires, you need to recalibrate the system. The calibration process requires approximately 30 minutes of cumulative driving at speeds between 30–65 mph (48–105 km/h). The vehicle must be stopped to begin calibration, and the process finishes automatically.

How do you calibrate a tire sensor?

To begin the calibration process, you need to press the TPMS button located near the steering column. Hold the button down until the indicator light blinks twice. At this point, you must drive for approximately a half hour to complete the process. Driving speeds should be between 30 to 60 miles-per-hour.

How do I calibrate my speedometer?

Press and hold the calibration button located on the speedometer, start the vehicle, and then release the button. Press that button again and then take the test drive. Once you have driven the distance needed, press the button once more and the speedometer will calibrate itself to accommodate the new tire size.

How much does it cost to reprogram a tire pressure sensor?

The average cost for tire pressure monitoring system relearn is between $35 and $44. Labor costs are estimated between $35 and $44. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.

Do tire pressure sensors need to be programmed?

These sensors must be programmed with the proper protocol/application information for the vehicle before they can be installed in the tire, and then must be relearned to the vehicle. Unfortunately, some shops overlook the necessary relearn step mistakenly believing the sensor programming did the trick.