How do you take the door panel off a Jeep Cherokee?
Gently pull out the plastic trim piece located behind the door opener handle. There is a tab on the rear edge that makes it relatively easy to remove. If necessary, you can use a flathead screwdriver to pry it out. Remove the small screw by turning it counterclockwise with the Phillips head screwdriver.
How do you remove the door panel on a Jeep Grand Cherokee?
The first step is to pull back the door opener handle and gently pry out the trim panel behind it with a small flathead screwdriver. Set the trim panel aside in a safe place. Then move to the bottom of the door pull handle well in the arm rest and pry open the screw cover with the small flathead screwdriver.
How do you open the back door on a Jeep Grand Cherokee?
How do you open the back window on a 2018 Jeep Grand Cherokee? Look on the back door of your Jeep, slightly above and to the right of the license plate. You will see a small black rectangular button. Press the button up and you will hear a click that unlocks that rear window.
How do you take the door handle off a 2015 Jeep Cherokee?
Remove the Door Handle
- Use a screwdriver to remove the two retaining nuts that attach the door handle to the door.
- Pull the handle out from the door.
- Pry off the handle rod from the control rod by removing the retaining clip with your hands.
- Pull the door handle free and clear of the Jeep Cherokee.
Can you take the doors off a Jeep Grand Cherokee?
If you have a door with damage on your Jeep Grand Cherokee, you can remove the door to repair it or replace it. The hinges are welded to the body of the Jeep but the door half of the hinge bolts to the welded section. There are only four bolts to remove to separate the door from the Jeep’s body.
How do you remove the inside door panel on a Jeep Liberty?
The tools needed to remove the door panel include a flathead screwdriver, a Phillips head screwdriver, and a 10mm socket with a 1/4″ drive ratchet. To remove the speaker, you’ll need a Torx T20 star bit screwdriver. To remove the power window motor, you’ll need a Torx T30 screwdriver.
How do you take the door panel off a Jeep Commander?
Remove the door panel Pry around the bottom and the edges of the door panel to release the clips holding it in place. Lift the panel up, disconnect any electrical plugs, and lift the door panel away from the door proper.