How many ball joints does a Jeep Grand Cherokee have?
A complete and detailed guide to replacing your Jeep’s ball joints. Applies to Jeep Cherokee (XJ) 84-01, Jeep Grand Cherokee (ZJ) 93-98, Jeep Wrangler (YJ, TJ and LJ) 87-06, and Jeep Comanche (MJ) 86-92. You may want to replace all four ball joints at the same time.
How do you change a CV axle on a Jeep Grand Cherokee?
How to Replace a Jeep Grand Cherokee Front Axle
- Break the front lug nuts loose with a tire wrench.
- Engage the emergency brake.
- Raise the Jeep onto jack stands, using the floor jack.
- Finish removing the lug nuts, and lift the wheels off and away from the vehicle.
- Remove the center spindle nut with a socket wrench.
Can you drive with bad u-joints?
A car with a bad U-joint will break down in a few hundred miles at the maximum. But if you have a bad U-joint and you are having a transmission fluid leakage, you should not drive your car since the U-joint may break down anytime and will cause damage to the brake line, drive shaft, transmission line and other parts.
What are the signs of a bad u-joint?
Symptoms of a Bad or Failing Universal Joint (U-Joint)
- Squeaking noise when starting to move (forward or reverse)
- “Clunk” with a ringing sound when shifting from Drive to Reverse.
- Vibration felt throughout the vehicle while moving forward at speed.
- Transmission fluid leaks from the rear of the transmission.
What sound does a bad u-joint make?
clunking sound
How many miles should U joints last?
In most cases, you have to grease your u-joints every 5,000 miles or so. When you fail to service your u-joints on a regular basis, they will fail. You don’t have to worry about this problem with maintenance free u-joints. Misalignment: This happens when you change the vehicle’s ride height.
Can you spray WD40 on U-joint?
WD40 isn’t a lubricant and shouldn’t be used as one. It will actually take good oil away from moving parts. Use spray silicone or a light oil for bearings and joints..
Will bad U joints squeak?
Common signs of a faulty u-joint include a squeaking noise, clunking sound when shifting, vibrations in the car, and transmission fluid leaking.
Can bad U joints cause hard shifting?
Additionally, can bad U joints cause hard shifting? Bad u-joints may put a strain on the transmission and cause unusual wearing of the internal parts which in turn causes more wear and creating leaks internal. The hard shifting sound like it is not a smooth transition into the next gear? That will no doubt be internal.
How do you lubricate a U-joint?
U-Joint Kit Lube Procedures
- Remove each bearing assembly and pack each journal cross lube reservoir with grease.
- Wipe a liberal coating of the same grease into the each bearing assembly, filling all of the cavities between the needle rollers.
- Apply a liberal coating of grease into the bottom of each bearing cup.
Do you need to grease new U joints?
Installation Procedure (Con’t) NOTE: The u-joint must be greased prior to installation. There is only enough grease in a new MOOG u-joint to keep the needles in place during assembly, which is not sufficient for operational lubrication.
What kind of grease goes in U joints?
U-joint and slip spline lubrication can have a significant impact on the operation and life of universal jackshafts especially in contaminated environments. For universal jackshafts, a highly quality lithium based EP NLGI 2 grease with good water tolerance and rust and corrosion protection is required.
How can a universal joint be inspected for wear?
Larger universal joints can be inspected for extreme wear by twisting the propeller shaft back and forth. Smaller joints can be tested by prying the trunnions back and forth with a large screwdriver.