How much does a hot tub with water weigh?
When filled with water, do not be surprised to find that it will weigh an average of 3000 lbs. If you are considering a 6 person to 8 person tub, these will often weigh close to 1000 lbs empty, and up to 6,000 lbs when filled!
How much does a 4 person hot tub weigh full of water?
Hot tub weights by size and capacity
Type of Hot Tub | Empty Weight | With Water Weight |
---|---|---|
Small 2-3 person hot tubs | 600 lbs | 2,575 lbs |
Medium 4-5 person hot tubs | 750 lbs | 3,700 lbs |
Large 6-8 person hot tubs | 800 lbs | 4,300 lbs |
Inflatable hot tubs (2-3 people) | negligible | 2,200 lbs |
What does a 7 person hot tub weigh?
On an average, a tub measuring 7 ½-foot by 7 ½-foot can hold 420 gallons of water and it can accommodate 6-7 people with an average weight of 185 pounds. The total weight of a hot tub with the above-mentioned measurements would be around 5,655 pounds(2).
Can a deck support a hot tub?
In general, most decks can withstand 100 lbs per square foot. So if a hot tub like the one in the example is under that weight, the average deck should be able to support it.
Do I need to reinforce my deck for a hot tub?
Hot tubs, however, are very heavy, especially when filled with water, and chances are that your existing deck can’t safely support it without additional reinforcement. Fortunately, reinforcing your deck in preparation for a hot tub is a relatively easy task.
How much weight can a 10×10 deck hold?
How much weight can a 10×10 deck hold? In short there’s no one right answer to “how much can my deck hold?” However, one rule of thumb to keep in mind while answering the question is that the answer commonly is that if a deck is properly designed, it’s built to hold 50 lbs. per square foot.
Will joist hangers support a hot tub?
Don’t use a ledger board or joist hangers when building a hot tub deck. Super-size to 2×10 joists installed on top of the beams and spaced at 12”o.c., 8”o.c. is preferable, though. Use brackets to maintain location on the beam and intermediate blocking for spacing and to prevent twisting.
Can you put a hot tub on grass?
It might seem like a good idea but you should not put a hot tub on grass. The hot tub might begin to sink into the ground over time, and it may or may not stay level. A hot tub requires a stable surface — whether it’s a concrete slab, reinforced deck, or firmly compacted soil with crushed gravel.
What if my hot tub is not level?
If your hot tub is out of level by an inch or less, consider using heavy-duty plastic shims to raise the low end. These shims are designed to be load-bearing and are an economical way to level your slightly off-kilter hot tub. Be sure to check your hot tub manufacturer’s guidelines on using shims safely.
How much does it cost to run power to a hot tub?
Modern manufacturers advertise the cost to run their hot tubs at about one dollar per day, with $50 per month at the high end. The energy cost of a hot tub varies based mainly on the heater, which usually draws between 1,500 watts or 6,000 watts.