How often do forklift trainers need to be recertified?
every three years
What is the first thing to do before driving into a trailer with a forklift?
Before driving your forklift into a trailer, you should chock the trailer wheels, support the nose of the trailer, inspect the dock plate, and check the trailer floor (all of these).
How many accidents occur on the loading dock?
Twenty-five percent of all industrial accidents occur at the loading dock. And for each accident that occurs, there are about 600 near-misses. Loading docks are flooded with potential danger, and without the proper training, procedures, equipment, and maintenance they are liable to deliver disaster at every turn.
How much space is needed for a loading dock?
Each truck bay should be at least 12 ft wide to provide enough space for the trailers, which are 8’0″ to 8’6″ wide, to back squarely to the dock. To reduce congestion, design 14 ft wide bays. If swinging trailer doors will be opening or closing at the dock, the center distance should be at least 14 ft (Figure 32).
How much does it cost to install a loading dock?
Budget $7,500 for a leveler from a reputable manufacturer. Cheap levelers come at a HIGH cost to your facility. This is nothing more costly than an injury at your loading dock.
What is the max slope for loading dock?
If heavy loads will be handled, slope should be no more than 3-5%. However, if space does not permit, you may increase the slope to an absolute maximum of 10%, and this will work only for light loads. Steep slopes force dock workers to load on an incline inside the truck and may cause loads to topple.
What is a raised loading dock?
Operating an Elevated Loading Dock Dock levelers are fixed to the end of the dock and are bookended by bumpers. This protects your dock and also gives the ability to bridge height differences between trailers. Though elevated docks are meant to be level with semi-trailers, not all semitrailers are made equal.
How tall is a loading dock door?
Depending on the application, there are three basic door heights that are typically specified. Keep in mind that the common dock height is 48″ – 52″ (1219 – 1321mm). 8′ (2438mm) high doors can accommodate many loading/unloading operations, but do not facilitate full floor to ceiling loading of product.
What is a loading berth?
Loading berth means an off-street space for the temporary parking of a vehicle while loading or unloading merchandise or materials and which abuts on a street, alley or easement.