Is a 2010 Dodge Avenger a good car?
Pleasant highway cruiser, desirable high-tech options, good crash test scores. Unrefined four-cylinder engine with outdated four-speed automatic, poor performance, cheesy interior materials, small trunk, stability control unavailable on SXT.
What wheel drive is a 2010 Dodge Avenger?
front-wheel
What motor is in a 2010 Dodge Avenger SXT?
2.4 L 4-cylinder
What kind of oil does a 2010 Dodge Avenger take?
Dodge Avenger 2010, Professional Series SAE 5W-20 Full Synthetic Motor Oil, by Red Line®.
How much oil does a 2010 Avenger take?
Pour In New 5W-20 Oil The 2.4L I4 engine’s total capacity for an oil change with filter replacement is 4.5 U.S. quarts (or 4.4 liters). Carefully pour in about 4 quarts of the engine’s 4.5 quarts total capacity.
How much oil goes in a 2010 Dodge Avenger?
Capacity: 4.5 quarts. (with filter)After refill check oil level.
What kind of oil goes in a Dodge Avenger?
Engine Oil
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 4.5 quarts. (with filter)After refill check oil level. |
| Torque: | 30 ft/lbs (Oil Drain Plug) |
What’s the best oil for a Dodge Avenger?
Castrol Edge Synthetic Motor Oil 5W-20 1 Quart.
Can 5w30 be used instead of 5w20?
In general, you can use 5w30 motor oil instead of 5w20. The 5w30 motor oil is more viscous than the 5w20. If the oil is more viscous, it will provide more protection against friction because it is more resistant to heat and does not easily break down.
How much oil does a Dodge Avenger need?
The Dodge Avenger with a 2.7L 6-cyl engine (engine code EER) takes 5.5 quarts (with filter) of 5W-20 synthetic oil. A new oil filter and a crush washer are required.
What type of oil does a 2011 Dodge Avenger take?
Mobil 1 Extended Performance Synthetic Motor Oil 5W-20 1 Quart.
How do you reset the oil change light on a Dodge Avenger?
To reset the oil change service light indicator system for a Dodge Avenger (after performing the scheduled maintenance) perform the following procedure.
- Turn the ignition switch to the ON position.
- Fully depress the accelerator pedal slowly 3 times within 10 seconds.
- Turn the ignition switch to the LOCK position.
How do you reset the change oil light on a 2010 Dodge Avenger?
How to Reset Oil Change Required Light on the Dodge Avenger
- Turn the ignition to “On” where the electronics are on, but the engine is off.
- Gently press the gas pedal all the way down three times within a ten second interval.
- Turn the ignition to “Lock“.
What do you do when the oil pressure light comes on?
When your vehicle warns you of an oil problem, what looks like an old-fashioned oil can will illuminate on your dashboard. If the oil light comes on while you are driving, get to a safe place and turn the engine off immediately. It is important to stop driving your vehicle because you may have run out of oil.
How do you reset the computer on a 2010 Dodge Avenger?
How to Reset a Car Computer Open up the hood. Remove the positive terminal cable from the battery using your pliers or wrench. Go to your fuse box in your car , and look at the diagram. Keep the car disconnected like this for two to three minutes to clear the computer’s memory.
How often should I change the oil in my 2013 Dodge Avenger?
Well a quality oil like Royal Purple or Mobil1 are ideal for any engine. And in my manual it states 6,000 mile changes. I ran it to 5,000 once and the oil still looked tan, and see through.
How much oil does a 2012 Avenger take?
Engine Oil 4.5 quarts. (with filter)After refill check oil level.