Is the 3400 engine good?
The 3400 isn’t a bad motor. Intake gaskets have always been a problem with these motors, but GM, Felpro and other makes, have significantly updated the gaskets so they last longer. I’ll take it, not a problem. Its a solid motor.
Is a 3.1 V6 a good engine?
Except for the notorious leaky intake manifold gasket problem that has plagued many of these engines, the 3.1L V6 has had a reputation for being a long-lived reliable engine. Consequently, there are still a lot of these engines on the road and people are still spending money keeping them running.
What size is a 2.8 motor?
Engine Size Chart
| Liters (L) | Cubic Centimeters (CC) | Cubic Inches (cid) |
|---|---|---|
| 2.6 | 2,557 | 156 |
| 2.6 | 2,606 | 159 |
| 2.8 | 2,786 | 170 |
| 2.8 | 2,803 | 171 |
What is a 3.1 engine?
The 3.1 V6 is a 60 degrees-between-the-cylinder-banks motor derived from GM’s X-car engine of 2.8 liters. The 3800 V6 is a 90 degree cylinder angle motor derived from a 60’s era V8 later sold to British Leyland and used in lots of Brit cars.
What does a 2.8 V6 weigh?
How much does a Chevrolet Citation Sedan 2.8 V6 weighs? The Chevrolet Citation Sedan 2.8 V6 weighs 1130 Kg / 2491 lbs.
How do I know what engine is in my car?
Find it in the lower corner of your windshield on the driver’s side. Your VIN number is your vehicle identification number and you can find your engine size by VIN number. In the series of numbers and letters, the tenth from the left denotes the model year and the eighth is the engine codes.
Where do I find the size of my engine?
Your VIN number is your vehicle identification number and you can find your engine size by VIN number. In the series of numbers and letters, the tenth from the left denotes the model year and the eighth is the engine codes. Just tell the store clerk those two characters and you’re in business.
What year is my engine block?
However, the most accurate way is to look at the serial number on the block, which is located on the drivers side, rear, on the extended part of the deck surface that goes over the bell housing area. The date code for the engine is built into the serial number after the first two numbers.
How do I know what LS engine I have?
To figure out what LS engine you’re staring at, just consult the RPO code. The easiest way to do this is to find the VIN and reference the 8th digit.
How do you tell if a 350 is a 4 bolt main?
Use the suffix code on the block and determine if the engine is original or not. That code can’t always tell you its a 4 bolt but if its the origianl motor in a 4 wheel drive 3/4 ton its almost a guarantee its a 4 bolt block.
Is a 4 bolt main better than a 2 bolt main?
Any time you increase horsepower, torque and cylinder pressure, you increase crankshaft load. It would take quite a bit more stress to rip-out 4 bolts than it would just 2, so that’s why the 4 bolt mains are stronger than the 2 bolt mains.
How much HP can a 4 bolt main 350 handle?
4. Bowtie blocks with splayed 4-bolt mains with center studs should handle over 1,500 HP, and are good to well over 8500 RPM.