What axle does my Ford Ranger have?
Identifying Your Axle From The Axle Tag: You can identify which axle you have by the tag attached to the inspection cover. Here is an example of an axle tag: Looking at that tag, you can see the gear ratio stamped on the lower left, and the axle size (ring gear diameter) stamped in the bottom middle.
What front axle is in a Ford Ranger?
Ford Rangers appeared with a reverse cut Dana 28 TTB (Twin Traction Beam) 4WD front axle in 1983. In 1990, Ford Introduced a 4.0L V6 to its engine lineup, and along came the larger Dana 35 axle to handle the increase in power….
| Specification | Dana 28 | Dana 35 |
|---|---|---|
| Pinion Stem | 1.312 Inch | 1.406 Inch |
What rear axle is in a Ford Ranger?
1998-2011 Ford Ranger Super Cab 4×4’s are frequently equipped with 8.8-Inch axles regardless of engine size. Click HERE for more Ford 8.8-Inch Information & Specifications. Dana M220: All 2019 – Present Ford Ranger’s come with a Dana Advantek M220 (220mm) rear axle.
What front axle is in a 1994 Ford Ranger?
The Dana 35 Twin Traction Beam Independent Front Suspension (IFS) front axle had a short production life of only 8 years. It was used in most 1990-1997 Ford Ranger pickups, some 1990 Bronco IIs, and all 1990-1994 Ford Explorers.
What vehicles have a Dana 35?
The Dana 35 (as well as the AMC-15) is found in a wide variety of vehicles. The most common Dana 35 applications are as a rear axle in the Jeep Cherokee, Jeep Wrangler, and Jeep Comanche and as a front axle in the Ford Explorer and Ford Ranger.
What is Dana 30 axle?
The Dana/Spicer Model 30 is an automotive axle manufactured by Dana Holding Corporation. It has been manufactured as a beam axle and independent suspension axle with several versions.
What vehicles have a Dana 30 axle?
Comanche, Cherokee, and Grand Cherokee Dana 30 The Comanche (MJ) and Cherokee (XJ) use a reverse cut Dana 30 and the Grand Cherokee (ZJ) uses a normal cut Dana 30. Like the YJ and the TJ, these axles use a 5 on 4.5″ wheel bolt pattern. All of these trucks use coil springs up front.
Can you run 35s on a Dana 30?
Yes, you may twist your axle housing or explode the carrier running 35s, but you could do just the same running 33s. Dana 30 (and 44) JK frontends will also benefit greatly from the installation of HD ball joints, axle shafts, and extra housing reinforcement, such as a truss. ‘Wheel on.
Can a Dana 30 handle 37s?
But if you wheel on trails where you need the tire size, you’re going to shatter some steel inside your axle. 37’s can be ran on a Dana 30 axle, but you will break stuff every once and a while. Depending on how hard you actually wheel. The most likely failure will be the ring and pinion.
Can Dana 35 Handle 35 tires?
Jerry Bransford said: 35″ tires are not recommended on a dana 35.
Is a Detroit Locker Streetable?
The Detroit Locker is an automatic locking differential. This means it is normally locked during straight-line driving and sends 100% of the available torque to both wheels equally. During turns and maneuvers, the internal components unlock to allow one wheel to spin faster or slower as necessary (free wheel).