What can I spray on my distributor cap?

What can I spray on my distributor cap?

Turn off the vehicle and spray the spark plug wires and the inside and outside of your distributor cap with WD-40. Using WD-40 to repel water from spark plugs, distributors, alternators, and batteries is a good way to prevent corrosion and keep moisture away.

How do you waterproof a distributor cap?

if your cap has a vent in the top of it, seal it. then its just like holding an upside down glass in the watter.. you just need to move the vent to the base of the dist. also, di-electric greese is your friend. also spray a bit of wd40 inside the cap.

How do I stop condensation in my distributor cap?

Step 3 – Keeping Moisture Out Replace the distributor cap. For extra protection run a bead of silicon caulk around the base of the cap. Replace all the wires, taking care to have all the wires in the right places. Try to start the car; it should turn over with no problem.

How do you fix moisture in a distributor cap?

Drying The Cap

1. Place the cap upside down, and spray it with your carburetor cleaner.
2. Shake the cap around gently, to allow the cleaner to reach every crevice.
3. Use a clean, lint-free, dry towel to dry the cap out completely. Leave in a warm place for an hour to complete the drying process.

What causes moisture in distributor cap?

Most likely, when you forded the Nile that night, you got water inside the distributor cap, and it’s causing the misfire by creating a short circuit. Eventually, as the engine heats up, the moisture in the distributor evaporates, the plug wires warm up and dry out a bit, and the cylinders all fire.

Can you clean the inside of a distributor cap?

Every time you disassemble the distributor cap, do not forget to mark the spark plugs cables. This will help you to assemble then back in the right way. After removing the cap, clean the inside of the cap using a clean, dry rag and then leave it in a warm area to dry out.

Can u clean a distributor cap?

NOTE: When cleaning your distributor cap, don’t use compressed air or solvent to clear out its vent. This can only lead to more damage on the cap. Instead, use a small brush to rid your cap of dirt.