What causes a fuse to keep blowing?
First, and most commonly, when too many lights or plug-in appliances draw power from the circuit, it can overload the capacity of the fuse and cause the metal ribbon inside the fuse to melt through. A mis-wired lamp, for example, can cause a short circuit and blown fuse if it is plugged into an outlet.
Can a fuse work intermittently?
If an intermittent causes a fuse to fail, replacing the fuse won’t fix the problem. A new fuse may restore power temporarily but, unless the underlying cause of the circuit overload is found and corrected, the fuse won’t last and will likely blow again.
Why does my electric motor start then stop?
If it starts to run, stops by itself, and then will start again after a while: it is pretty likely to shutting down due to internal overload protection. Check to see if the motor spins freely; perhaps the bearings are worn.
How can you tell if an electric motor is bad?
With a multimeter set to low ohms (usually 200), test between each winding terminal and the metal casing of the motor. If there is any reading on any of these then the motor is bad, do not use it. You may find that when it runs ungrounded that the casing becomes live at up to supply voltage.
What happens when the start capacitor goes bad?
If a run capacitor fails, the motor can display a variety of problems including not starting, overheating, and vibrating. A bad run capacitor deprives the motor of the full voltage it needs to operate correctly.
How do you check if a capacitor is working?
One way to check if a capacitor is working is to charge it up with a voltage and then read the voltage across the anode and cathode. For this it is necessary to charge the capacitor with voltage, and to apply a DC voltage to the capacitor leads. In this case polarity is very important.
Whats the difference between a start capacitor and a run capacitor?
The start capacitor creates a current to voltage lag in the separate start windings of the motor. The current builds up slowly, and the armature has an opportunity to begin rotating with the field of current. A run capacitor uses the charge in the dielectric to boost the current which provides power to the motor.
What are the 2 replacement rules when changing a start or a run capacitor?
As a general rule of thumb, electric motor start capacitors can be replaced with a micro-farad or µF or mfd rating equal to or up to 20% higher µF than the original capacitor serving the motor. On the replacement capacitor the voltage rating must be equal to or greater than the original.