What does the magnetic brake do on a baitcaster?
The Magnetic brakes work on the principal that the closer the brakes are to the spool, the faster the spool will slow down within the cast and by default, the further the magnets are from the spool the freer the spool is to spin.
What does the spool tension knob do?
While braking systems are great for larger restrictions on how much line comes off, the spool tension knob allows for even finer tuning. For this reason, anglers use this mechanism to adjust for different lures that feature varying weights, helping to give them the perfect ratio for casting.
What is magnetic cast control?
Magnetic systems work on a principle called Lenz’s law, which simply means that the spinning of your aluminum spool is retarded by a magnetic field. To control this setting, a set of magnets inside the reel is moved closer to or away from the reel spool via an external knob.
Why does my reel keep Backlashing?
Backlashes occur when your lure slows down during or after a cast, but the spool keeps spinning, which results in a tangled mess of line. Today’s baitcasters feature sophisticated braking systems and anti-backlash mechanisms that make it easier for anyone to cast without experiencing line overruns.
How do I stop backlash?
Listed below are a few ways to help prevent, or lessen, backlash.
- Choose the best equipment.
- Adjust the brake system and spool tension and do a test cast.
- Practice short distances.
- Use the wind to your advantage.
- Practice makes perfect.
What causes fishing line to tangle?
Slack fishing line is a big culprit when it comes to line tangles. As you reel in slack line, this creates loose coils on your spool. When you cast, these loose coils will come off the spool quickly compared to the line around it, causing the coils to overlap on themselves as they leave the reel and tangle up.
Should I soak my fishing line?
It is not necessary to soak your line for a long time. Typically, you only need to soak it for a few minutes before you start the spooling process and then leave the spool in the water while you are winding it onto the reel.
How do I keep my fishing line from tangling on my reel?
After a few revolutions of the reel handle, drop your rod to within 18 inches of the spool of line to introduce slack into the line. You’ll notice a few loose coils due to the memory of the fishing line, but if you see any tight twists or kinks in the line, simply flip the spool of line over.
Why does my braided line keep tangling?
“Wind knots may occur after a sudden acceleration at the beginning of the cast, when the braid collides into the rod guides and causes a loop that continues to accelerate,” says Capt. Examine your spinning reel, and confirm that the spool rotates properly when winding or it could cause knots, points out Meyer.
Can you Backlash a spinning reel?
You can easily get a backlash on a spinning reel if you put too much line on the spool or if the line that you are using is too heavy/thick for the reel.
How long does fishing line last on spool?
There is no official answer for the life of these products, but we’ve compared estimates from various fishing publications and have gathered that monofilament has an average shelf life of two to three years, while fluorocarbon lines can last up to seven or eight years without losing its edge.
Does fishing line weaken with age?
High quality, braided fishing line lasts for many years without needing replacement. However, monofilament and fluorocarbon line will eventually go bad after a couple seasons of use in the water. Even unused fishing line will loose peak performance after a few years if stored improperly.
How often should fishing line be replaced?
Monofilament lines should be changed at least once a year, though many anglers recommend changing them after every fishing trip. Their durability depends on how much you use them: If you are a heavy fisher, you should change monofilament line 3 to 4 times a year. Moderate fishers can change it 2 to 3 times a year.