What is a valet button?

What is a valet button?

The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system. To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode.

How do you reset a 2002 Isuzu Rodeo?

Turn the ignition key to the “on” position. Wait 5 minutes, then shut off the ignition and reinsert the fuse for the ECU to restore power. Then, turn on the ignition and wait for the check engine light to reset itself.

What is the purpose of a valet switch?

The valet switch is used for turning the valet mode on and off. Valet mode prevents the security system from arming, yet allows the convenience functions (door lock & unlock, etc.) to operate normally.

How do I reset my valet remote starter?

Press and hold the “Valet” button again and press and release the starter button on your remote. Wait for the horn to chirp again and release the “Valet” button to end the programming sequence.

What does a viper valet switch look like?

Enable Valet Mode It is a small, black, momentary button that is usually mounted in an accessible, but not obvious location towards the bottom of the driver’s side dash. A common location would be on the driver’s kick panel cover, or on the side of the center console (if the vehicle has one).

Where is the Viper valet switch located?

The first method is to locate the “valet switch”, which is a small, black, momentary switch usually located towards the bottom of the dash on the driver’s side of the vehicle.

How do I get my Viper 7752v out of valet mode?

How do I get my viper out of valet mode?

1. Open any door.
2. Press lock button, the system will arm.
3. Press unlock immediately, the system will disarm.
4. Press lock button immediately, the system will enter/exit Valet mode.
5. The led will turn on when entering and off when exiting.

How do you bypass a Viper alarm system?

How to Disable a Viper Car Alarm

1. Press and hold the “Arm” button on your remote until the alarm turns off wirelessly.
2. Open your car door, and use the “remote valet” method to stop the alarm.
3. Insert your key into the driver’s-side door, and unlock the car; this will disarm the system on some models.

Why is my Viper alarm not working?

If the procedure mentioned above does not work simply turn the key off then back on and press the valet switch two times. If this does not work turn the key off then back on and try it three times. Continue this up to five and one of them should disarm the alarm.

How do you turn off a car alarm without the remote?

Ways to stop a car alarm without a keyfob

1. Check your owner’s manual. Every vehicle is different.
2. Lock your doors.
3. Turn the car on.
4. Turn the ignition to on and wait.
5. Pull the fuse for the alarm.
6. Pull the wires for your alarm.
7. Disconnect the battery.