What is the best gear ratio for Jeep Wrangler?
In many cases, 5.13 is recommended above for 35s, when 5.38 would actually be a better choice. However, unless you have a Rubicon model (that has both a Dana 44 front and rear axle), then you will have no choice but to use 5.13 gears, unless of course you swapped in Rubicon axles.
Will Regearing improve gas mileage?
Regearing will help correct the odometer and the perceived power loss, but not significantly for the MPG.
Can you run 35s on stock JK?
You can indeed put 35s on a stock Jeep Wrangler JK and drive around town without issue. However, if you are going to hit the trail, it’s going to rub.
Should I Regear with 33s?
You don’t need to regear with just 33’s. Most likely, the reason behind you ‘drag’ is the width of the tires. You sure won’t be turning them over any time soon. The regearing won’t do damage or harm to the jeep, but it ‘may’ void your warranty on the axles.
What gear ratio do I need for 31 inch tires?
Gear Ratio And Tire Size Calculator
| 3.31 | 4.27 | |
|---|---|---|
| 30″ | 2410 | 3109 |
| 31″ | 2332 | 3008 |
| 32″ | 2259 | 2914 |
| 33″ | 2191 | 2826 |
How much does it cost to Regear a differential?
Re: How much $$ to re-gear diffs Labor should be around $250/axle. That’s based on a 3-hour job per axle at a shop rate of $75/hour and rounded-up for sales tax. Parts kits (“Master” parts kits, including all bearings, races, ring bolts and shims) are about $125/axle.
What are 4.10 gears good for?
Most late model Mustangs and many other sports cars come equipped with standard 3.55 gears in their rear differential, however by adding 4.10 gears they can effectively make their drag times faster and deliver more power to the wheels faster.
Do you have to Regear both axles?
1- yeas you have to regear both front and rear axles, if you do not you will cause major damage to your drive line, because the wheels front and rear will not be turning at the same speeds.
How long does it take to Regear a truck?
It shouldnt take longer than two days max if they have a lot of buisness. You should call back the reputable shop and ask them if there is a specific day you can drop you car off in the morning. That way you can pick it up later that day.
Is it hard to Regear a truck?
It’s not impossible and many take the time to learn how to do it but if you do decide to tackle the job, don’t plan on being able to regear both axles in a weekend. It’s going to take some time to figure it out because there’s a lot of trial-and-error work that needs to be done to get it done correctly.
What does it mean to re gear a truck?
Re-gearing can bring your vehicle either back to factory settings which can save you money on gas if your vehicle is a daily driver. Or if your Jeep or Truck’s primary purpose is to off-road, an updated gear ratio will provide the performance you need to tackle any terrain.
How much does it cost to Regear a truck for bigger tires?
If you can drop off the rear 3rd member and front diff expect prices to range from $400-700. If you drop off the truck add another $300-500. for a v6 go with 4.56s especially with a manual tranny. 4.88s work very well for mainly trail use.