What is the biggest cam for stock 350 vortec?

What is the biggest cam for stock 350 vortec?

5 Best biggest cam for stock 350

1. Thumper cam 350- COMP Cams CL12-600-4.
2. Chevy 350 Thumpr Cam- COMP Cams 12-602-4 -Best roller cam for 350 with Vortec heads.
3. Best cam for 350 chevy truck- COMP Cams CL12-212-2 Magnum.
4. Best cam for 350 with vortec heads- COMP Cams CL12-242-2 Xtreme Energy 224/230.

What is the best cam for a 5.7 Vortec?

A Complete Buying Guide of Top 5 Best Cam For 350 With Vortec Heads 2021

1. Comp Cams 12-602-4 Big Mutha’ Thumpr Flat Cam.
2. Edelbrock 2102 Camshaft and Lifter Kit.
3. COMP Cams CL12-600-4 Thumpr Flat Cam and Lifter Kit.
4. COMP Cams K54-412-11 Roller Cam K-Kit for GM LS GEN III/IV.

How much HP does a RV cam add?

You could take a seventies 350 smog motor, give it a 3 angle valve job, add an RV cam, a single 4 barrel aftermarket intake with Quadrajet carb, and a set of headers and pick up about 50 HP and 3 or 4 MPG over a stock engine.

How much HP can a 4-bolt main 350 handle?

4. Bowtie blocks with splayed 4-bolt mains with center studs should handle over 1,500 HP, and are good to well over 8500 RPM.

How much HP can a stock SBC crank handle?

A typical small-block cast crank is good up to 500 hp, while a 4340 forging can take 1,500 hp. “Billet cranks are similar to forged cranks in that they also start out as a big ingot of steel.

How much power can stock SBC rods handle?

Registered. If you put good rod bolts in them they are good to 450-500hp.

How many rpms can a stock 350 handle?

Piston speed w/a 3.75″ stroke isn’t a limiting factor until you get up around 7500 or thereabouts, for a 350 it’s close to 8000 RPM. This is for “run of the mill” good parts, not “as good as there is” parts, as I’m sure you understand.

How much horsepower can a stock 400 crank handle?

400 cranks are nodular iron and will handle 500 hp easy.

What is a 383 stroker?

A 383 stroker has a 0.030 over bore of the stock 350, giving you 4.030 as a bore diameter. Putting the 400 crank in the 350 increases the stroke to 3.750. Other than that, all the other dimensions stay the same. If you do the math, you will get 382.6; round up and you have 383 ci.

How much does it cost to bore a 350 to 383?

The machine work is usually in the $250~300 range for bore & hone to size ( including cam bearing install if desired). Bottom edges of block may need light relieving to clear rod bolts.