What size is a flywheel bolt?

Flywheel Bolts – Thread Size 7/16-20; Thread Length 0.900 In.

How do you put a clutch in a Honda Civic?

Slide the alignment tool into the clutch disk and position it on top of the new flywheel. Take the pressure plate and mount it on top of the clutch plate….Step 10 – Mount the clutch

Figure 24. Mount clutch disc to flywheel.
Figure 25. Mount and align pressure plate.
Figure 26. Replace the throwout bearing.

How much does it cost to replace a clutch in a Honda Civic Si?

The Best in Auto Repair The average cost for a Honda Civic clutch replacement is between $1,309 and $1,478. Labor costs are estimated between $646 and $814 while parts are priced at $664.

How do you put a clutch in a Honda?

How to Change a Clutch on a Honda

Remove the negative (black) battery cable.
Raise the car using the floor jack and support it with jack stands.
Place the floor jack under the transaxle, but don’t raise the transaxle, raise the jack enough so that the transaxle is supported.

What side does the clutch go on?

The flush side of the clutch disk goes towards the engine. For 5VZ V6 clutches, the spring side faces the flywheel.

Can you put a clutch in backwards?

A clutch disc can be put in backwards, and it will cause the clutch to never disengage due to contacting the crankshaft-to-flywheel bolts and pushing the disc against the pressure plate. Pull your clutch and make sure it hasn’t been damaged, and flip it over.

Which way do steel clutch plates go in?

PLACE ALL STEELS IN ONE DIRECTION. This is the “first” of two keys to watch out for when working with the clutch assembly. If you place the steel’s cut-edge all in the same direction, they will not fight each other.

What does a new clutch feel like?

Here are some of the signs your clutch is going: Squeaking or unusual grumbling noise when pressure is applied. The clutch pedal sticking, vibrating or appearing to feel spongey or loose. Poor acceleration but still having the ability to rev your engine.