What size rims are on a 2002 Ford Escape?

What size rims are on a 2002 Ford Escape?

15-16″ diameter, 6.5-7″ width

What is PCD on a wheel?

The Pitch Circle Diameter (PCD) is the diameter of the circle which passes through the centre of all the studs, wheel bolts or wheel rim holes. The easiest way calculate the PCD is as follows: 1) Measure the distance ‘S’ between two adjacent studs from the centre of each hole.

How do I check my PCD?

of any wheel or hub with an even number of holes can be measured from the inside of one hole directly across to the outside of the hole opposite. To calculate the P.C.D. of a five stud wheel or hub, measure ‘X’ from the inside of one hole to the outside of the next hole and multiply by 1.7012.

How do I check my PCD flange?

How Calculate PCD (Pitch Circle Diameter) of a Flange?

  1. As accurately as you can, measure two adjacent holes using a varniar scale and calculate the PCD; then calculate for-
  2. 4 holes: multiply by 1.414.
  3. 8 holes: multiply by 2.613.
  4. 12 holes: multiply by 3.864.
  5. 16 holes: multiply by 5.126.

What does PCD 100 mean?

100 is the simplest. So lets say you have an alloy with 4×100 PCD. It means it has four holes and the distance between one bolt hole and the one opposite to it is 100 mm. It simple means the circumference on which all 5 holes are drilled, it has a diameter of 114 mm. Same way 6 bolt wheel PCD is measured.

Does pcd114 fit PCD 100?

No can do. PCD 100 how to fit PCD 114.3? cannot go in.

What does PCD 114.3 mean?

Pitch Circle Diameter

Are all 4 stud wheels the same?

Not all 4 stud wheels are the same Pitch Circle Diameter (PCD) although a 100 PCD is most common. Use this wheel suppliers site and key in each of the two cars and you’ll that Acura wheels should mount on the Rio.

How do you find out if wheels will fit?

The two easiest ways are to check the sticker plate in your car, it should be located inside the driver side door, or look online for the vehicle specifications for your exact make and model. That should tell you the standard rim size.

How do I know if alloys will fit?

There are 10 aspects that are critical for your choice of alloy wheel to fit properly:

  • The Wheel PCD (Pitch Circle Diameter / Stud Pattern)
  • The Front and Rear Wheel Offset (ET)
  • The Wheel Diameter.
  • The Front and Rear Wheel Width/s.
  • The Front and Rear Tyre Size.
  • The Wheel Load Capabilities.
  • The Tyre Load Index.
  • The Centre Bore.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top