What type of fluid goes in a Jeep transfer case?

What type of fluid goes in a Jeep transfer case?

Mercon, Dexron, ATF+4, are all just as good inside the transfer case. Jeep only recommends the same type of ATF that the automatic transmission requires to keep things simple.

How do I identify my Jeep transfer case?

The easiest way to identify the transfer case input is by identifying the stock transmission that Jeep used. The 21 and 23 splined output shafts vary on different transmission models. The AX15 transmission is always 23 spline shaft and extends 1/2″ beyond the face of the transmission.

What RPO code is transfer case?

RPO code is NR4. AUTOMATIC TRANSFER CASES.

How do I know if I have a Dana 20 transfer case?

The Dana 20 is a cast iron transfer case, having a passenger-side front output and a centered rear output. It has the same “Texas” front mounting input flange as does the Dana 18. Markings on the Dana 20 can vary, but most start with a C18-15-24… Some confuse them for a large case Dana 18 because of this.

How do I know if I have a Dana 18 transfer case?

Spicer/ Dana 18: The Dana 18, as it is commonly referred, is easily identified as it has both front and rear outputs offset to the passenger side of the Jeep. It also has 2 shifters one for high and low, the other to engage/disengage 4-wheel drive. There are 5 different varieties of the Dana 18 transfer case.

What fluid goes in a Dana 20 transfer case?

The transfer case needs gear oil. 85w-90 is typical but a lighter weight like 75w-90 can be used in colder climates or 85-140 or similar can be used in hotter climates.

How do I know if I have a Dana 300 transfer case?

Identification. The Dana 300 is a cast iron transfer case, having a passenger-side front output and a centered rear output. It has a round, six-bolt front mounting face. It has a smoother case design with fewer cast-in bosses for mounting features.

How do you remove the transfer case on a Dana 18?

Remove the five bolts on the sheet metal power take-off cover on the rear of the transfer case and remove the cover. Remove the cotter pin in the nut at the center of the input gear and remove the nut.

Can you flip a Dana 300?

To overcome this issue, Downeast Offroad (DEO) has developed the Dana 300 Flip Kit. It allows you to flip the transfer case over to convert it to driver side front output. It also converts the transfer case from a single shifter to a twin stick shifter.

How does twin stick transfer case work?

Twin stick shifters allow independent control of the high/low and 2wd/4wd sections of your Toyota gear driven transfer case. This allows access to low range 2wd operation. It also allows you to shift in and out of 4wd while driving on the trail without the need to stop.