Where can the key or switch be placed in the circuit?

Where can the key or switch be placed in the circuit?

Notice that the key or switch can be placed anywhere in the circuit. When the switch is in the ‘ON’ position, the circuit from the positive terminal of the battery to the negative terminal is complete. The circuit is then said to be closed and the current flows throughout the circuit instantly.

Where should a switch be placed in an electric circuit Why?

The circuit works the same no matter where you put the switch. Part of the electrical code (for house wiring) says that the switch should always go between the hot conductor and the load. This is for safety.

What do you mean by an open circuit?

: an electrical circuit in which the continuity is broken so that current does not flow.

Can a switch be placed anywhere in a circuit?

A key or a switch can be placed anywhere in an electric circuit.

How does a switch affect a circuit?

If a switch is added to a series circuit, then it controls (turns ON and OFF) everything in that circuit. Adding a switch to the above circuit gives us the diagram below. If the switch is open, no current will flow at all. Only part of the current flows through each device.

How do you connect a switch to a circuit?

The negative terminal connects to the charge, and the electrons drive through the circuit. The load receives the current and returns it via the positive terminal to the power source. The electrical switch is inserted in this loop.

Where can the key or switch be placed in the circuit required to answer single choice?

The key or switch can be placed anywhere in the circuit.

Which is useful to join or break the circuit?

A ‘switch’ is an electric device that is used to make or break a circuit. When the switch is in ‘OFF’ position, then the circuit is not complete. Then, the circuit is called an Open circuit.

What happens if a wire has continuity?

Continuity means, are two things electrically connected. So if two electronic parts are connected with a wire, they are continuous. You can always use a resistance-tester (ohmmeter) to figure out if something is connected because the resistance of wires is very small, less than 100 ohms, usually.