Where does the alternator exciter wire go?
Where does the alternator exciter wire go? The wire is connected to the “L” terminal of the alternator. The exciter wire is used to turn on the voltage regulator.
How does a one wire voltage regulator work?
The only thing you need to hook up on a one-wire alternator is a charge wire from the terminal on the alternator to the positive terminal on the battery (or any positive battery source). Once the voltage regulator turns on, the alternator will remain on and charging until the engine comes to a complete stop.
How can you test a voltage regulator?
The best way to test a voltage regulator is with a multimeter, and what you do is you put your multimeter clamps directly on the battery terminals. Positive read to positive and black to negative. And you said it to voltage, and with the car off, you should have a little over 12 volts. That’s that’s a healthy battery.
How does a 2 wire voltage regulator work?
It is a zener diode voltage regulator. It cuts off the tops of the positive ac phase and almost all of the negative. Basically it shorts excess voltage to ground. The input resistance would be the coil itself in bike applicaton.
Does a regulator rectifier need to be grounded?
The R/ R does not need to be grounded or bolted. It will work if you were holding it in your hand. Adding that the R/R is grounded through the wire harness. If anyone is having a problem check the connectors and the grounds.
How does a 12 volt regulator rectifier work?
In any case, the regulator rectifier converts the AC power into DC power, then regulates the DC power to ensure that the power doesn’t go over around 14.5 volts. At this point, the DC voltage routes to the battery of the bike.
Is a voltage regulator necessary?
The voltage regulator is needed to keep voltages within the prescribed range that can be tolerated by the electrical equipment using that voltage. Voltage regulators also are used in electronic equipment in which excessive variations in voltage would be detrimental.
When should you use a voltage regulator?
Voltage regulators are designed to maintain and stabilise voltage levels. Regulators are found in most electronic devices, and can be used to step-down and control voltage outputs from a high voltage source, dissipating excess energy as heat.