Where is SRS module located?
First find the srs computer module. In most cars it is under the center console that is between the two front seats, or center of the dash on the floor. In most GM cars it is under the driver or passenger seat.
How do I know if my airbag module is bad?
The way you know if the sensor is at fault or not, before scanning your airbag system for faults, is to simply look at the “Passenger Airbag Off” light. If there’s no one in the seat, the light should illuminate. If there is someone in the seat, the light should turn off, signifying that the system is armed.
What happens if you unplug airbag module?
How Do I Disconnect the Airbag Control Module? Disconnecting the airbag unit from the harness without unplugging the battery may trigger the airbags to deploy or may cause damage to the computer system. After disconnecting the positive battery cable, you should wait three minutes before removing the computer module.
Is it safe to reset airbag module?
Our certified technicians at MyAirbags recommend resetting your vehicle’s airbag module if the vehicle has been involved in an accident. Resetting the airbag module diminishes the need for any additional programming, and when properly installed into a working system, the airbag light will turn off.
Can airbag be reset?
If the airbags have deployed, they may be able to be reset in some makes and models of vehicles, as long as they are not damaged. This basically involves stuffing the airbag back into the airbag module and then resetting the airbag light. However, newer vehicles typically are not allowing the airbags to be reset.
How much does it cost to reset an airbag module?
Number 1 — Reset Airbag Light You’ll need to hire a professional to come in and examine the airbags before you continue to drive the car. This process can take several hours of time and usually costs a few hundred dollars, although depending upon the type of car it may be up to about $600.
Do crash sensors need to be replaced?
Some crash sensors may automatically reset after a sudden jolt, but it’s difficult to know whether or not a crash sensor has been damaged or has failed to reset unless it’s inspected. Therefore, replacement should be considered.
What needs replaced after airbag deployment?
When they were first introduced, mechanics could reset some airbags. Today, however, mechanics must replace the safety devices after each deployment. This is true regardless of whether it was the airbag in your steering wheel, your passenger-side dash, your side panels, or your seat.