Where is the computer module on a 2007 Ford Explorer Sport Trac?

Where is the computer module on a 2007 Ford Explorer Sport Trac?

Thanks for the great question. The code is located on the Smart Junction Box which is located on the drivers side kick panel and up behind the dash a little. You will need a flashlight to see the 5 digit code.

Where is the door code on a 2008 Ford Explorer?

2007, mecury mountaineer, ford explorer, door keyless entry code is located on the fuse panel under driver side dashboard, it is called SJB smart junction box, it is a 5 digit code printed about 1 inch from the bottom of the fuse block, you can not see the number off hand because it faces the metal frame of the car.

Where is the factory code on a Ford Explorer?

Find and remove the panel covering the RAP. Using a flashlight, locate the removable panel and turn two thumb screws counterclockwise to remove the plastic panel. Shine the flashlight onto the RAP module and look for the label containing the 5 digit factory code.

Where is the factory-set code on a Ford?

Reset the Keyless Code If the owner’s manual is lost, you can find the factory code on the label of the Remote Anti-Theft (RAP) module. This is usually located on the left panel toward the back of your vehicle. This panel should be removable with a screwdriver.

How do you reset the door code on a 2017 Ford Explorer?

How To Reset Ford Explorer Keyless Entry Key Pad Door Code 2011-…

1. Enter the factory-set five-digit code. Enter your keyless entry door factory code.
2. Press and release the 1·2 keypad briefly. Press the button within five seconds.
3. Press and hold 1·2 keypad for two seconds.

How do you reset the keypad on a Ford Explorer?

To reprogRam the keyless entry pad on a Ford Explorer, type in the factory code found in the owner’s manual. Within 5 seconds, press the 1-2 button, and enter 5 digits that are personal and simple to remember. New numbers must be pressed within 5 seconds of one another to be stored by the Explorer.

How do you reset the keyless entry on a 2008 Ford Explorer?

INSERT key into Ignition and TURN from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm Programming Mode. Within 20 seconds press any button on first keyless remote fob. Door locks will cycle to confirm programming.