Where is the fuel pump fuse located on a Ford Expedition?
The fuse panel is located below and to the left of the steering wheel by the brake pedal. Remove the panel cover to access the fuses….Power distribution box Ford Expedition.
| Mini Fuses | Amps | Circuits Protected |
|---|---|---|
| 10 | 20 | Fuel Pump Relay |
| 11 | 20 | Charging System |
| 12 | 10 | Rear Wipers Up and Down |
| 13 | 15 | WOT Relay |
Why did my Ford Sync stop working?
If your phone still has trouble connecting with SYNC, the following troubleshooting tips may be able to help. On your phone, turn Bluetooth Off, then On. Press the Phone button > scroll to System Settings > Press OK > scroll to Connect Bluetooth Device > Press OK > scroll to [select your phone] > Press OK.
Where is the Ford Edge backup camera reset button?
Look in the area above the back windshield, and locate the camera. You should be able to find a button on the camera that is labeled “reset”. Now, press down this button and count for 10 to 20 seconds. At this point, the camera should reset, and now be back to its original factory settings.
Why is my reverse camera reversed?
Selfie cameras flip the picture so our brains interpret the image as a mirror image. It’s so that as you’re taking the picture, things move the way you expect them to. If it didn’t flip the front camera, you’d have a much harder time moving the camera /yourself into the position you want.
Why is my reversing camera not working?
Camera Says ‘No Signal’ If it’s a Wi-Fi camera, and it was working previously, it likely means that the camera needs a reset. You could also check the wiring and the power cables as a wire may have frayed or a cord may have become disconnected. If the problems persist, chances are you need a new reversing camera kit.
Why is my back up camera screen black?
If your backup camera display is flashing or giving you black and white static, it’s likely the case that you have a fraying wire or a faulty connection. Make sure all of the cables and connections in your backup camera system are fully connected and repair any damage.
Does a backup camera need a fuse?
If either problem is occurring, it means the camera or monitor fuse is blown. Typically the fuse box location is under the steering wheel. Look up the exact fuse used to power your equipment. Once the fuse is in place and you power on the vehicle, the backup camera should work properly.
Is there a fuse for backup camera?
This fuse goes with the backup camera. In some vehicles, the fuse box is located under the steering wheel while in some others it can be found under the dash. In many vehicles, it is located in the glove box.