Where is the heater blower resistor located?

Where is the heater blower resistor located?

The heater blower motor resistor is often found beneath the dashboard. It is located in the heater and air conditioning compartment. It’s connected to the air conditioning system, where it can adjust the speed of the blower motor fan.

How do you remove a heater resistor?

Difficulty

1. Remove the negative battery terminal.
2. Locate the blower motor resistor on the passenger side under the dash board.
3. Disconnect the electrical connector to the blower motor resistor.
4. Remove the screws or bolts to the blower motor resistor and remove the resistor.
5. Installation is the reverse of the removal.

Why did my fan stop spinning?

One of the most common reasons fans stop spinning is because of a dead capacitor. Each air conditioning system has several capacitors, including the start capacitor, which sends signals to the motor, and the run capacitor, which keeps the motor running. Capacitors can go bad over time and need to be replaced.

Why did my ceiling fan stopped working but light still works?

If your ceiling fan stopped working but the light still works, check for a humming sound. This could be indicative of a blown motor capacitor, which is often caused by overheating. While inspecting the motor housing, look for a small black box connected to the pull cord.

Why would a fan not work but the light does?

If your ceiling fan quit working, but the light still works, and you hear a humming sound, you might be looking at a blown motor capacitor. They can burn out for a number of reasons, the major two reasons being old age or overheating. Checking this part of the fan is also relatively simple.

How do you fix a Lasko fan that stopped working?

Try unplugging the fan for at least 15 minutes, and then plug in the fan again. When you do this, make sure the fan is OFF while it is resting. Also, make sure you turn the fan to ON after plugging it back in.