Where is the jack on a 2004 Jeep Liberty?
4. Locate the jack as shown. For the front tires, place it (rearward) of the notch on the body weld seam behind wheel to be changed. For the rear tires, place it under the axle by the wheel to be changed.
How do you get the spare tire off a 2004 Jeep Liberty?
Fit the jack handle extension over the drive nut located in the rear cargo area inside the vehicle. Use the lug wrench to rotate the nut counterclockwise until the spare is on the ground with enough slack in the cable to allow you to pull the tire out from under the vehicle.
Is it OK to jack up a truck by the differential?
When the tire shop guys lift a car by the differential, they’re probably being safe. Likewise, if you do the same thing from home with a good hydraulic jack, you’re probably being safe. If your vehicle manufacturer says that the differential is a recommended lifting point, then you’re definitely being safe.
Can I jack up my truck on the pumpkin?
So we know it can carry the weight of the truck when it’s in the air, too. TOM: And, in fact, that pumpkin and axle are designed to carry much more than just the weight of the truck. RAY: So with a proper jack, the pumpkin is a perfectly acceptable jack point. We do it all the time, too.
Can you put Jack stands on the rear axle?
Jack stands are the most secure and safe way to raise a vehicle. Always be sure to place jack stands under the control arms, frame crossmember or frame members. If you need to lift all four wheels off the ground for exhaust or transmission work, the rear axle is often the preferred placement for jack stands.
How do you jack up a rear tire?
Place the jack stands under the vehicle, near where the jack is touching it. Raise the stands until they’re high enough to just fit under, and lock them in place. Lower the jack until the vehicle is resting on the jack stands. Jack stands hold your vehicle up safely.
What do you do if you don’t have a jack stand?
In a pinch, dense pieces of wood stacked lengthwise can be used to support weight in lieu of jack stands. Cinder blocks should NEVER be used, as they are not weight rated and could crumble without notice. Another emergency solution is setting the unused tire between the chassis and the ground as you change them out.