Where is the OBD port on a 92 Honda Accord?

Where is the OBD port on a 92 Honda Accord?

Re: Diagnostic port on 92 Accord LX (jtracing) The service check connector is under the dash on the passenger side. Pic below. You jump the two wires on the plug with a paperclip or wire, then count the flashes from the check engine light.

Will AutoZone check codes?

Many drivers don’t realize that AutoZone, the nation’s largest auto parts chain, will do the following services free of charge: Read the codes on your check engine light. Test your battery’s voltage.

Can AutoZone clear check engine lights?

AutoZone can help you diagnose the cause of the light and help you correct it. In most cases disconnecting the battery for a few minutes then reconnecting will clear the fault codes and turn off the light. But if the issue has not been resolved it will come back on, in some cases almost immediately.

How do you reset the check engine light on a Honda Accord?

Steps on How to Reset Your Check Engine Light

1. Turn off the ignition and let the engine cool.
2. While wearing safety glasses and gloves, locate the negative terminal on your car battery.
3. Loosen the nut on the negative terminal with a wrench.
4. Reconnect the negative cable and tighten it with your wrench.

Why is my Honda Accord check engine light on?

Honda Accord Check Engine Light Flashing Diverse natural reasons for a Check Engine Light are damaged oxygen sensor, a malfunction with the fuel injection system, dirty mass airflow sensor, faulty head gasket, faulty emissions control part, or defective spark plugs to name a few.

What does a flashing check engine light mean on a Honda Accord?

If the check engine light in your Honda Accord starts blinking, that means that the problem needs immediate attention and your Honda should be brought in promptly. This blinking light usually indicates a severe engine misfire allowing unburned fuel to be dumped into the exhaust system.

How do you clear the code on a Honda Accord?

How to reset the check engine light on a Honda Accord – Quora. Turn the ignition key to the power accessory position. This will illuminate all the lights on the instrument panel without the engine running. Continue to hold down the select/reset button until the maintenance required light goes out.