Where is the PCM located on a 2000 Dodge Ram?

Where is the PCM located on a 2000 Dodge Ram?

The Dodge Ram 1500 series PCM can be found in the engine compartment on the right side of the firewall.

How do you reset the computer on a Dodge Ram?

To reset the computer in your RAM 1500, take the following steps:

1. Identify your battery’s negative cable.
2. Disconnect the negative cable from the battery.
3. Wait 20 minutes so that all systems have shut down.
4. Reconnect the negative cable.

How do you reset the computer on a 2001 Dodge Ram 1500?

Turn the ignition to the start position for a count of 30 to 40 seconds. Turn it back off, then go back to Your battery, and replace the negative terminal to it’s original connection. The PCM should now be reset.

How do you reset the computer on a 2013 Dodge Ram 1500?

Disconnect the battery cables, put the battery on a charger on it for about ten or fifteen minutes, and then reconnect. Start truck, let idle till it reaches operating temperature, turn it off and count to 15, and restart. That’s an easy way to “reset”.

How do you reset the computer on a 2003 Dodge Ram 1500?

turn the key on and hold for 15-20seconds, then reconnect battery cable and go. Disconnect the negative battery cable, turn key to Start position for 30 seconds, remove key, and reconnect Negative battery cable.

How do you clear the codes on a Dodge Ram 1500?

How To Reset the Check Engine Light on a RAM 1500

1. Find your battery under the hood and disconnect the black/negative cable.
2. Wait 20 minutes for the power reserve to expire. The RAM 1500 check engine light should reset automatically during this time.
3. Now, just reconnect the black/negative cable.

How do you reset the check engine light on a 2020 Dodge Ram 1500?

To reset a RAM 1500 check engine light, all you have to do is:

1. Disconnect the negative cable from your battery.
2. Wait 20 minutes.
3. Reconnect the negative cable.

Is it bad to clear codes on a car?

If your main reason for buying an inexpensive scanner is to reset the check-engine light, know this: clearing the code and turning the light off doesn’t mean your issue has gone away. Some check-engine light warnings are temporary—like the aforementioned loose fuel-filler cap or a rare engine misfire.

Can you clear stored codes?

Yes, you can clear the codes without using a scanner. In fact, the check engine light will turn back on in a matter of seconds if the problem still persists. Clearing the CEL is easy… fixing the cause of the problem is the tricky part!