Where is the radiator drain plug on a 2004 Dodge Dakota?

Where is the radiator drain plug on a 2004 Dodge Dakota?

At the bottom of the driver side radiator tank (facing toward the fender) is a 3/4″ long flat handled plug. Twist your hand (with a pair of pliers) up there from the back side of the bumper fascia.

How do you unclog a radiator drain plug?

Just pull the lower hose with the engine running and the radiator cap off. Flush it out by: reattaching hose, filling radiator, wait for thermostat to open, pull lower hose, and repeat.

Where is the drain Petcock on a radiator?

The petcock is usually always located in the corner of the radiator. Once located, get a pan of some sort, such as a disposable aluminum pan from the store, and place it directly under the petcock. When in place, remove the petcock and let the coolant drain into the pan.

What is the purpose of a radiator Petcock?

The major function of the radiator drain petcock is not only to stop coolant from leaking through the hole underneath the radiator, but it serves a reverse role too. The petcock has been placed in modern cars to make draining a radiator an easy task.

How much does it cost to replace a radiator valve?

Cost to Fit Radiator Thermostats Good quality valves cost around £15 each and it doesn’t take long to fit them. The central heating system is often drained before they’re fitted and refilled and then tested after installation.

How much does it cost to remove old radiators?

The removal of about 6 radiators and refinishing the floors where those radiators were, will run about $1800. 7. The total cost? It is in the neighborhood of $18,000 for the entire scope of work depending on the size of your home.

Can I remove just one radiator?

Depends if it is a one pipe or 2 pipe system, you need to find the pipe that the radiator is fed from. If it’s a 2 pipe system then yes you can but if you are removing it permanently then you should really cap the pipe as close to the main feed pipes as possible.

How do you take a radiator off to paint behind it?

Just follow these step-by-step instructions to remove your radiator for decorating.

1. Turn Off The Radiator.
2. Place Towels & Bowl Beneath The Radiator.
3. Undo The Radiator Valve Nut.
4. Drain Water From The Radiator.
5. Get The Last Few Drops Out Of The Radiator.
6. Move To The Other Valve.
7. Remove Any Remaining Water.