Where is the rap module on a 2004 Ford Explorer?

Where is the rap module on a 2004 Ford Explorer?

This should be in the owner’s wallet card which is usually kept in the glove compartment. If the owner’s manual is lost, you can find the factory code on the label of the Remote Anti-Theft (RAP) module. This is usually located on the left panel toward the back of your vehicle.

Where is the rap module located?

RAP System On Expeditions and F-Series, the RAP module can be seen under the driver’s side of the dash against the firewall. Usually, the part number tag of the RAP module will also contain the five-digit code for the key pad on the door.

Where is the factory code on a Ford Escape?

The default OEM keyless entry code for Your Ford Escape can be found in the back of Your owner’s manual. Depending on the year there may also be a decal that is located above the brake pedal that has the code on it. If You do not have the owner’s manual, or the decal then You will have to contact a Ford dealership.

How do you reset Ford keyless entry?

How to program your keyless entry keypad

1. Enter the factory-set code.
2. Within five seconds, press the 1-2 button on the keypad.
3. Enter the personal, five-digit code you’d like to use.

How do you reset the keyless entry on a 2004 Ford Explorer?

2004 Ford Explorer Keyless Entry Remote Fob Programming Instructions

1. Close all doors and then open drivers door and press the UNLOCK button on drivers door panel while door is open and insert key in ignition.
2. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN.

How do you reset a push button padlock?

Take these steps to reset your lock:

1. Pull up the shackle to open the lock.
2. Rotate the shackle 90° counterclockwise and press all the way down.
3. Hold down the shackle and set your own combination by turning dials.
4. Turn the shackle back as normal. The setting is now complete.

How do you reset a hardened combination lock?

Begin spinning the combination wheel counterclockwise. You’re going to start with figuring out the last number, and work your way backwards. Pull up on the latch as you rotate the dial. When you feel the hinge inside lock, write down the number on the dial and keep spinning.

How do you reset a combination lock without the code?

Spin the dial clockwise a few times to reset the lock and set it at 0. Apply upwards pressure on the shackle and turn the dial clockwise. The lock will catch several times, allowing for slight movement back and forth between two numbers. Write down the number in the middle.