Where would you not park a forklift?

Where would you not park a forklift?

Never park or leave the forklift in any doorway, entrance, emergency exit or in front of fire extinguishing equipment.

Where is a safe place to park a forklift?

Park or leave your forklift in a safe area away from traffic Never leave the forklift in walkways, in front of fireboxes, in front of emergency areas and eyewash stations. You will never know when accidents will happen and these facilities should be clear from any obstruction.

How do you park a forklift truck?

Parking Safety Rules

1. Always try to find a level surface to park on.
2. Lower forks, or the forklift attachment, all the way to the ground.
3. Put the gear into neutral.
4. Make sure the wheels are straight.
5. Set the parking brake every time you park the forklift.
6. Turn off the engine before dismounting the forklift.

What should you do if a forklift truck begins to tip over?

If the forklift is tipping over, protect yourself by staying put:

1. Stay in your seat and do not attempt to jump off.
2. Lean away from the falling direction of the lift.
3. Hold onto the steering wheel and make sure you’re stable.

Why do forklifts not tip over?

At the back of every forklift is a counterweight. The size of this counterweight will depend on the capacity of the forklift. The counterweight acts as a balance for the weight being lifted by the truck’s forks. As long as the center of gravity is inside the wheelbase for the vehicle, the forklift won’t tip over.

Should you jump from a tipping forklift?

If the forklift does tip over your instinct may be to jump. In a forklift tip over, you should: remain seated and don’t lean out of the forklift. brace your feet, hold tight and lean away from the point of impact.

When a forklift is loaded Where is the center of gravity?

When unloaded, the forklift’s center of gravity is right about here. When a load is added, the forklift’s center of gravity moves towards the forks. Heavier loads shift the center of gravity forward even further. Raising the load also shifts the center of gravity forward.

How often should you inspect a forklift?

Federal OSHA requires that forklift vehicles have to be inspected at least daily, or after each shift when used around the clock. You will find this requirement in the Powered Industrial Truck standard at 1910.178(q)(7).

What must be done daily to a forklift?

What should an operator inspect during the visual pre-use check?

• General condition and cleanliness.
• Floor – clear of objects that could cause an incident.
• Overhead – no obstructions.
• Nearby objects to avoid as you drive away.
• Fire extinguisher – present and charged.

Does OSHA require strobe lights on forklifts?

Forklift Strobe Lights, Blue Spotlights, and Red Side Pedestrian Lights: Strobe lights, blue spotlights, and red side lights on a forklift are not required by OSHA, but adding these lights can help support good safety practices in some work environments, and are generally meant as an approach or warning light.

How do you inspect a forklift?

Check for leaks, cracks and visible defects everywhere on the forklift. Check mast chains visually; avoid the use of hands. Test mast chain tension by lifting the load backrest to eye level—the mast chains should be level and any tilting may signify stretching or broken rollers.

Why are there 3 pedals on a forklift?

To begin with, every forklift comes equipped with an accelerator and a brake pedal. That third pedal is called an Inching Brake. Its function is twofold. It initially acts as a brake and secondly disengages the transmission, allowing the engine speed to increase or decrease without affecting the drive of the forklift.