Which of the following person is responsible for watching pedestrians while operating a forklift?

Which of the following person is responsible for watching pedestrians while operating a forklift?

drive in reverse. It is the lift truck operator’s responsibility to make sure no one walks or stands under raised loads or forks. As an operator of a lift truck: It is your responsibility to watch for pedestrians.

Do pedestrians have the right of way over forklifts?

OSHA states the pedestrian has the right of way; therefore, operators must be on constant alert. The forklift operator is required to slow down and sound their horn at doorways, intersections, blind spots and when entering or exiting a building.

Who is responsible for forklift safety?

The department has also its own trainer to conduct necessary forklift training every now and then when needed. In a small company, forklift training is the responsibility of a supervisor or leader, either it is part of the person’s job or as his actual and sole responsibility.

What is the safe distance between forklifts and pedestrians?

4 ft.

How far away from a moving forklift should you stay?

Falling distance of an object from a pallet or 15 feet, 5 Feet both sides, 5 Feet Rear of Forklift. do so (ALL CLEAR). Do not pass under the forks while in operation. in operation and a fix object.

When you are placing a load How high should you raise the load?

Lift the load and tilt it back a little more before traveling. Keep the forks 6 to 10 inches above the ground to avoid potential hazards on the ground. Remember that forklifts are top-heavy. Carry the load low and tilted back.

What should you not do when a load is elevated?

One area of particular concern is on ramps, slopes, or otherwise uneven terrain. Never raise a load or turn on an uneven surface. In such cases, your center of gravity will quickly move outside of the stability triangle.

Can you jump off a forklift?

Only use a 12-volt negative ground battery to jump start your forklift. Bring the booster battery as close to the dead forklift as possible so that the jumper cables reach. But make sure the trucks aren’t touching each other.

What class lift trucks should not turn on an incline?

PEDESTRIANS AND FORKLIFTS SHOULD NEVER OCCUPY A RAMP OR INCLINE AT THE SAME TIME, IF THE OPERATOR OF A CLASS 1, 4, & 5 IS CARRYING A LOAD THAT BLOCKS THEIR FORWARD VISION ON LEVEL SURFACES, THEY ARE TAUGHT TO DRIVE IN REVERSE. BUT WHEN APPROACHING A RAMP OR INCLINE, THAT LOAD MUST FACE UPHILL.

Should you turn a lift truck on a ramp or slope?

Loaded forklifts must be driven with the load pointed up the ramp (good standard practice is to ALWAYS drive with the load pointed up the ramp or slope).

What direction should the lift be driven down a ramp when carrying a load?

When going down a ramp, drive in reverse with the load and keep the forks pointed up the slope. When traveling without a load, the forks should always point down the slope. The forklift operator should also drive in reverse up the ramp or drive forward when going down the ramp.

When going down ramps with a 10 percent grade on higher loads of a forklift should be?

When driving on ramps with a grade of 10 percent or more with a loaded forklift, you must always keep the load uphill, even if it means driving in reverse down the ramp.

Who has the right of way in warehouses?

Operators should yield the right of way to pedestrians: This is an OSHA recommendation that all forklift drivers should be aware of. Because of the size and power of the forklift, operators should stop and wait for pedestrians to clear the area before proceeding along their route with caution.

What should an operator do immediately after they find a problem with a lift truck?

Report any problems identified in daily check to the supervisor immediately. Check with your jurisdiction for any requirements regarding frequency of checks, and maintenance.

What is the most common cause of injuries and fatalities when using a lift truck?

Almost 80% of forklift accidents involve a pedestrian. In the United States, 1 out of every 6 workplace deaths are forklift –related. Where most people are concerned about being struck or run over by a forklift, this may prompt them to stand beside the forklift where they think they are safest.

How long does it take a lift truck to stop at full speed?

It will take another 10 feet for the forklift to come to a full-stop. If the forklift is going 8 mph, the distance jumps to 42 feet. At a speed of 9 mph the distance jumps up to 51 or more feet.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top