Why does my air only work on high?

Why does my air only work on high?

When a blower resistor fails, the highest fan speed usually is the only one that still works because it essentially bypasses the resistor and receives the maximum amount of voltage. When the resistor is working, it reduces the amount of voltage going to the lower fan speeds, so the fan runs slower.

How do you replace the blower motor resistor on a 2002 Pontiac Grand Prix?

Gently pull down and back on the blower resistor pack, rocking gently side to side to slide the pack off of the screw that you loosened. Once it pops free, the blower resistor pack will pull straight down and out for complete removal from your 2002 Grand Prix.

What does heater blower resistor do?

The blower motor resistor is an electrical component that is a part of the vehicle’s heating and air conditioning system. It is responsible for controlling the blower motor’s fan speed.

Where is the blower motor on a 2004 Pontiac Grand Prix?

1 Answer. The blower motor is under the dash. Check under the glove compartment area.

Where is the blower motor fuse on a 2005 Pontiac Grand Prix?

The Pontiac Grand Prix has a blower motor that is regulated with a fuse located in the fuse panel inside the glove box.

Where is the mall PGM fuse 2006 Grand Prix?

glove box compartment

How do you program a key fob for a 2006 Pontiac Grand Prix?

Press down and hold the “Unlock” and the “Lock” buttons at the same time. Continue to hold them for 14 total seconds, during which you will hear two chimes; one at seven seconds and one at 14 seconds. These two chimes indicate that the remote is synchronized and programmed, respectively.

What is the mall PGM fuse?

The MALL PGM fuse, when removed, will put the MALL (aka, the Body Control Module) into programming mode. This is used for programming keyless entry fobs.

Do 2006 Grand Prix have remote start?

With the correct VIN of a car that has the option the BCM can be programmed with the Tech 2. Futhermore GM Sells a Accessory Remote start kit for the 2006-2008 Grand Prix. By pressing a button on the key fob, the remote start system starts your parked vehicle.

What fuse controls remote start?

There is no fuse for just the remote start ! Remote vehicle start (RVS) begins as an RF message received by the remote control door lock receiver (RCDLR) from a keyless entry transmitter.

How do you program a 22733524?

Press and hold the door unlock switch. While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF. Release the door unlock switch. The doors will lock and unlock to confirm the program mode.

How do I program an aftermarket key fob?

How to reprogram a key fob

1. Replace the batteries inside the key fobs.
2. Get inside the car.
3. Turn on the ignition.
4. Press the lock button on the remote key.
5. Listen for a Lock Sound.
6. Programming additional remotes.
7. Turn off the ignition.
8. Step out from your car and test the result.

Can I program my own key fob?

DIY Key Fob Programming Depending on the age and model of your car, you may be able to program a replacement yourself. The procedure for do-it-yourself key fob programming can vary: Some automakers provide instructions in their owner’s manuals. Information can be found in many cases on the internet.