Why does my John Deere mower die when engaged?
If a pulley doesn’t spin freely, it can cause the engine to die when the blades are engaged. The pulleys in your lawn tractor are driven by the drive belt, and turn the spindles. If a pulley doesn’t spin freely, it can cause the engine to die when the blades are engaged.
How do I know if my lawn mower clutch is bad?
“Normally” when a clutch is going bad it will start to show when you engage the PTO. A common symptom would be for the clutch to be slow to engage if it’s been running for a while and is hot. Once engaged they usually stay engaged until you shut them off.
Why does my lawn mower die after I start it?
If your lawn mower starts, runs briefly, then dies these are the four most common reasons that’s happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.
Why does my lawn mower only run on full choke?
Lawn Mower: Only Runs With The Choke On. If your lawnmower will start and run with the choke on but dies when the choke is turned off, it may have a problem with the carburetor. The carburetor brings air and fuel together and mixes them in the perfect ratio for combustion before they enter the engine.
Why do I have to use starting fluid to start my lawn mower?
If you haven’t used your mower in a while, or the engine is cold, starter fluid can help get your mower started. Starter fluid is also a great tool to help you diagnose the problem when your mower does not start.
Will a bad spark plug cause a lawn mower not to start?
A dirty or fouled spark plug can cause your lawn mower to not start. It can also work itself loose, causing issues. If the spark plug appears to be seated correctly but the engine doesn’t start, a new one may be in order. For a few dollars, this easy fix can get your small engine working again.
Will a dirty carburetor cause a misfire?
A hesitation, stumble or misfire that occurs when the engine is under load can be caused by a faulty power valve inside the carburetor. If the diaphragm has failed or the valve is clogged with dirt or fuel varnish deposits, it must be replaced. A new power valve is usually included with a carburetor rebuild kit.