Why is my trunk light on?
What the trunk open warning light means. As soon as the trunk is secure, the light should go out. If it doesn’t turn off by itself, then the switch may be broken or malfunctioning. Dirt and debris can get lodged into the latch which can inhibit the opening and closing of the latch.
What does the car sliding symbol mean?
Share this Post: What Does the Car Skidding Warning Light Mean? When you see the symbol of a car with squiggly lines behind it become illuminated, and likely flashing, it indicates that your vehicle stability assist program is engaged.
What does the orange car symbol mean?
When you see an orange symbol of a car leaving skid marks on the road, it can mean one of three things. If it flashes briefly, it’s simply telling the driver that the traction control system is doing its job and preventing wheelspin.
What does a red lightning bolt mean on a Dodge Charger?
The Red lightning bolt of death means the car’s computer thinks there is no communication between the gas pedal and the throttle bottle. It is called an Electronic Throttle Control, or ETC for short.
How do you reset the electronic throttle control on a Dodge Charger?
Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds.
How important is throttle position sensor?
The throttle position sensor (TPS) is an essential part of your vehicle’s fuel management system, tasked with ensuring that a precise blend of air and fuel is routed to your engine. This sensor works in tandem with others sensors to optimize acceleration, cruising speed and fuel economy.
Can a bad TPS cause a car to run rich?
Since the throttle position sensor has a major effect on proper air/fuel mixture for burning, inaccurate readings can cause too much fuel to injected into the combustion chamber. This will cause a rich air/fuel ratio which will result in poor fuel economy.
What is the function of TPS sensor?
A throttle position sensor is used to measure how open the throttle valve is and therefore controls the amount of air which can flow into the engines intake manifold.
What should TPS be at idle?
At idle is should be zero or a couple of degrees. Press down on the gas pedal very S-L-O-W-L-Y until the throttle is all the way open. If the TPS has a worn spot, most likely it will be between 0 and 20 percent throttle opening. Try holding the throttle between 0 and 20 percent to see if you get a steady reading.