Why does my Jeep Commander Say perform service?

Why does my Jeep Commander Say perform service?

That is just a message that tells you it is time for maintenance (oil change, tire rotation, etc.) Your owners manual will have a maintenance schedule that outlines what services need to be performed at each mileage interva, so look up the schedule and do what it says according to your mileage.

Why does my car says perform service?

All this is is a feature that tells you when to change your oil, instead of relying on the trip odometer or service stickers. Changing the oil will not reset it. you have to do that manually every time you change the oil.

What does perform service mean on a 2007 Jeep Grand Cherokee?

KEN. The Electronic Vehicle Information Center (EVIC) displays a perform service message when distance to service interval has been reached, indicating that regular service and maintenance is due. After performing necessary services, reset service distance by selecting a distance to service interval. .

How do I get rid of Jeep perform service?

Check your owners manual for specific details.

1. Turn on the engine.
2. On the vehicle’s dash, press the “Step” button until “Miles to Service” is displayed.
3. Press and hold the “Reset” button, near the “Step” button, until the “Miles to Service” flashes and resets. Verify the “Perform Service” light goes away.

What does perform a service mean?

vb. 1 to carry out or do (an action) 2 tr to fulfil or comply with. to perform someone’s request.

How do you clear the error code on a Jeep Grand Cherokee?

How to Reset the Fault Code on a Jeep Cherokee

1. Pull the release lever to open the hood from inside the vehicle.
2. Open the hood and place the support rod into position to prop up the hood.
3. Remove the nut connecting the negative battery terminal to the battery, using an open end wrench.
4. Allow the computer to reset.

How do you reset the perform service on a Jeep Grand Cherokee?

How to Reset the Jeep Grand Cherokee Service Required Message

1. Turn the ignition switch to the “ON” position without starting the vehicle.
2. Press the gas pedal to the floor slowly three times within 10 seconds.
3. Turn the ignition off. Wait 10 seconds and start the engine.