What type of oil does a 1996 Dodge Ram take?

What type of oil does a 1996 Dodge Ram take?

SAE 10W-30 is preferred.

What type of oil does a Dodge Ram 2500 take?

The Doge Ram 2500 uses SAE 15W-40 motor oil. Dodge also recommends that You use synthetic oil any time that You have to change it.

What kind of oil does a Dodge Ram van take?

The 3.6L Pentastar® V6 engine should be lubricated with a synthetic blend oil, preferably one with an oil weight of SAE 0W-20. However, the 5.7L HEMI® engine should be lubricated with a synthetic oil blend with a weight of SAE 5W-20.

How much oil does a ram ProMaster take?

6 liters (5.9 quarts) of 5W-20 engine oil.

How do I change the oil in my RAM ProMaster?

Ram Promaster Oil Change (3.6L) Procedure: Remove engine oil fill cap. Loosen engine oil drain plug and let oil drain into pan using the 13mm or 1/2″ socket or wrench. Remove oil filter using the 24mm or 15/16″ socket and ratchet. With the oil filter cap removed, remove and replace housing o ring and filter.

How do you reset the oil change light on a Dodge ProMaster?

On a 2018 ram promaster-city the change oil light can be reset by first putting the ignition key in the on position without starting the engine. Then slowly pressing the accelerator pedal all the way down and releasing it three times. Finally you will turn the ignition back off.

How do you reset the oil change light on a RAM promaster 2500?

Oil Change Light Reset Ram Promaster 2500 2016 2017 Procedure

1. Turn ignition to the “RUN” position.
2. Slowly press and release the accelerator pedal 3 times within 10 seconds.
3. Turn ignition off.

How many quarts of oil does a 2012 5.7 Hemi take?

7 Hemi uses SAE 5w-20 full synthetic oil. It has a capacity of 7 quarts.

How do you clear the service required on a Dodge?

To reset the “Perform Service” indicator system (after performing the scheduled maintenance) refer to the following procedure:

1. Turn the ignition switch to the ON position (Do not start engine).
2. Press and release the brake pedal two times.
3. Fully depress the accelerator pedal slowly two times within 10 seconds.

How do you clear the codes on a 2012 Dodge Cummins?

Turn the KEY “ON” and do not start the starter yes. Depress the pedal slowly to the ground, and release. TURN KEY OFF. that should work.

How do you reset the check engine light on a Cummins ISX?

Cycle the key switch to the ON position for 30 seconds, then cycle the key switch to the OFF position for 30 seconds. Start the engine and let it idle for 1 minute. The fault code status displayed will change to INACTIVE immediately after the diagnostic runs and passes.

How do you reset the Dodge def system?

Locate the negative cable, while making sure to leave the positive alone. Pull the negative cable off. Now, wait for about 30 minutes to an hour. Once You have done this You can hook the cable back up.