Do you need smoke detectors in every room?
Presently the California State Building Code requires that smoke alarms be located in 1) the hallway outside the bedrooms 2) in each bedroom and 3) on every floor regardless of whether there is a bedroom on that floor.
Does every bedroom need a CO detector?
“CO alarms should be installed on each level of the home and outside sleeping areas. Smoke alarms should be on every level of the home, outside sleeping areas and inside each bedroom.” However, the CPSC does not recommend the placement of carbon monoxide detectors in the attic of a home.
How many smoke and CO detectors do I need?
According to the International Association of Fire Chiefs, carbon monoxide detectors should be installed on every floor of the home, including basements. Smoke alarms should always be installed in a central location outside of each sleeping area and on every level of the home.
Where is the best place to put a smoke detector in a bedroom?
Install smoke alarms inside each bedroom, outside each sleeping area and on every level of the home, including the basement. On levels without bedrooms, install alarms in the living room (or den or family room) or near the stairway to the upper level, or in both locations.
Can smoke alarms be wired to lighting circuit?
1.18 A smoke alarm, or smoke alarm system, that includes a standby power supply or supplies, [ie AC with battery back up], can operate during mains failure. It can therefore be connected to a regularly-used local lighting circuit. ……………
How far does a smoke detector have to be from a light?
300mm
Should smoke alarms be RCD protected?
the rcd protection of a smoke alarm circuit should operate independently of any rcd protection for circuits supplying socket-outlets or portable equipment. 1.21 Any cable suitable for domestic wiring may be used for the power supply and interconnection to smoke alarm systems.
What circuit are my smoke detectors on?
> The smoke detectors are most likely connected to a breaker that won’t normally be turned off by a homeowner. Typically it is wired to the furnace circuit. Open up the panel, it should be the only breaker with 2 hot wires connected to the breaker.
What circuit should smoke alarms be on?
Residential smoke alarms should be wired on a dedicated circuit. It’s a good idea to have at least one light or receptacle-on the same circuit, to alert the homeowners in case the circuit breaker ever trips. Interconnected alarms are usually wired in a daisy chain, using 14-3 or 12-3 cable.