How do I bypass anti theft on my Jeep Cherokee?

How do I bypass anti theft on my Jeep Cherokee?

Press the power door-lock switch on the keyless entry fob. Close the driver’s side door. Leave all doors closed for about 16 seconds until the Vehicle Security Light on the instrument cluster stops flashing quickly. When the light flashes at a slower rate, this signifies that the system has been reset and rearmed.

How do you turn off the security system on a Jeep Grand Cherokee?

First, grab Your remote keyless entry fob, and take a look at the buttons. You should see an image of an opened padlock. This is Your unlock control. Simultaneously press down both the lock and unlock buttons, holding them down until the clanging alarm noises stop.

How do you bypass the security system on a 2000 Jeep Grand Cherokee?

Insert your key and turn the drivers side door lock to the right , then left and then right again this will reset the security system.

How do you reset the security system on a 2001 Jeep Grand Cherokee?

How to Reset the Anti-Theft in a 2001 Jeep

1. Enter your car wth your ignition key and your theft remote, and press the Lock button on your remote five times in 10 seconds.
2. Insert your key into the Jeep’s ignition cylinder, and then turn the key to the “Run” position.

How do you bypass the chip key on a Jeep?

Simple Bypass

1. Remove the head of your key from the blade by using a pair of pliers to ease it gently off in a back-and-forth motion.
2. Use a hot glue gun to place a quarter-sized dot of glue underneath your steering column as close to the ignition as possible.
3. Test your plain key on your car.

How do you turn off the alarm on a 1999 Jeep Grand Cherokee?

How to Disable a Jeep Cherokee Car Alarm

1. Make sure nothing is actually wrong.
2. Press the unlock button on your key fob, if your vehicle isn’t equipped with the “Keyless Go.” This should turn the alarm off and prevent it from sounding until the vehicle is locked.

Where is the alarm fuse on a Jeep Grand Cherokee?

The fuse is located in the fuse box inside, under the dash on the driver’s side-pry open the box and remove it.

How do you reset the alarm on a 97 Jeep Grand Cherokee?

Inside drivers side door panel for purple yellow wire. Ground it out with another wire by splicing it and connect both wires together. Then touch opposite end of the extra wire to metal. Youll hear the ticking stop.

How do you turn off the alarm on a 1998 Jeep Grand Cherokee?

Try unlocking with the key in the driver door, passenger door, and hatch. That should disable the alarm, or you can unlock with the key fob and that will also disarm the alarm.

How do you turn off the security on a 1995 Jeep Grand Cherokee?

Normally to disarm it, press ‘unlock’ on the remote fob. Otherwise, put the key in the door locks and go ‘lock-unlock’ several times. Try this in all 3 door locks.

How do you turn off the alarm on a 2001 Jeep Grand Cherokee?

Disconnecting The Battery

1. Locate the hood release latch on the front of the Grand Cherokee and open the hood.
2. Locate the negative terminal on the Cherokee’s battery.
3. Loosen the terminal with a pair of channel locks.
4. Remove the terminal from the Cherokee’s battery to disable the car alarm.

How do you reset the alarm on a Jeep Cherokee?

Open the driver’s side door, with all other doors closed. You’ll then need to press the LOCK button on the key fob. Then, close the driver’s side door and keep all doors closed for at leaSTSRXteen seconds. The security dash light should stop flashing quickly, indicating that the security system has been reset.

Why does my Jeep alarm keep going off?

Your Jeep Wrangler alarm can go off intermittently due to multiple reasons, some which are a weak battery, bad BCM (body Control Module) or a bad sensor.

How do you reset the security system on a 2003 Jeep Grand Cherokee?

Get inside, and shut the door. Now, turn the key in the ignition to the on position. Do not crank the motor. Repeat turning the ignition on and off two more times, for a total of 3 repetitions.

How do you turn off the alarm on a 2003 Jeep Grand Cherokee?

To reset the alarm on the 2003 jeep grand cherokee you need to lock all the doors, then unlock the driver side and put the key into the on position. Now turn it off and then back on twice and it will reset.

How do you turn off the alarm on a 2000 Jeep Cherokee?

Start the jeep and look at the little box and you will find one screw that is holding the alarm box in place. remove the screw and disconnect the wires going to it. At this point you can turn off the jeep.