How do I measure my well depth?
Carefully drop the weight into the well and lower it until it stops dropping. Take up the slack and mark the string at ground level. Pull up the weight from the well and measure it from the bobber to the mark, and that will be your depth to water, or head.
How do you shock a well?
Mix 2 quarts bleach in 10 gallons of water; pour into well. Connect a garden hose to a nearby faucet and wash down the inside of the well. Open each faucet and let the water run until a strong chlorine odor is detected, then turn it off and go to the next one. Don’t forget outdoor faucets and hydrants.
How often should you shock a well?
every 3 to 5 years
Can I pour hydrogen peroxide in my well?
From time to time, it may be desirable to use hydrogen peroxide to decontaminate the entire well because some of the odor-causing bacteria also produce sulfuric acid, which will corrode the pump in the long run. Some of the iron bacteria can also produce a musty, fishy or oily smell in the water.
Can I put chlorine tablets in my well?
Chlorine granules, tablets and liquid chlorine in the form of household bleach can all be used to disinfect your well. Don’t use stabilized swimming pool chlorine products or non-chlorinated “pool shock” products, as they are not effective enough to clean your drinking water.
How many chlorine tablets go in a well?
If you have a drilled well with a submersible pump, drop about 15 tablets for every10 feet the pump is above bottom of the well (most pumps are set at least twenty feet off the bottom of the well). This will assure that the area of well below the pump will be treated.
Can I use pool chlorine tablets in my septic system?
The answer is no. Chlorine tablets for swimming pools are not designed to treat wastewater — only calcium hypochlorite tablets have been approved by the EPA for use in aerobic systems.
Can I use pool chlorine to shock my well?
Shock chlorination is the process by which home water systems such as wells, springs, and cisterns are disinfected using household liquid bleach (or chlorine). Shock chlorination is the most widely recommended means of treating bacterial contamination in home water systems.
How do you shock a sand point well?
Typical recommended chlorine concentration to shock a well is 3 pints (6 cups or 48 fluid ounces) of household bleach for every 100 gallons of water in the system (or in the well if you’re only treating the well itself).