How do I program my Jeep Liberty garage door opener?

How do I program my Jeep Liberty garage door opener?

Simultaneously press and hold both the Homelink button you want to program and the hand-held transmitter button. 4. Continue to hold both buttons and observe the indicator light. The Homelink indicator will flash slowly and then rapidly after Homelink has received the frequency signal from the hand-held transmitter.

How do I sync my Jeep garage door opener?

Take your old garage door opener and keep it around 3 inches away from the Homelink system of your vehicle. Select one of the buttons of your Homelink system to act as the garage door opening switch for all future uses. Push these buttons together for about 10 seconds.

How do you program a key fob for a 2012 Jeep Liberty?

Keyless Remote Key Programming Procedure:

1. Insert first programmed key into ignition and turn ignition switch to ON for 5 seconds.
2. Turn ignition switch to OFF and remove key.
3. Insert second programmed key into ignition and turn ignition switch to ON.
4. Turn ignition switch to OFF and remove key.

What does the 2X mean on my jeep key?

If your vehicle is equipped with a Remote Start System, the 2X button will allow you to start your vehicle before you get in.

How do you program a 2012 Jeep key fob?

How do you reset the keyless remote control on a Jeep Grand Cherokee?

Turn the key in the ignition back to the “Off” position then quickly back to the “Run” position within 20 seconds of programming your last remote. Turn the car off and remove the key from the ignition to complete the programming sequence.

How do I program my Jeep Grand Cherokee remote?

How to Program a Jeep Door Opener

1. Sit in your Jeep with the engine off. Press the first and third buttons on your Homelink system at the same time and hold them down for 20 seconds.
2. Select one of the three Homelink buttons to train.
3. To train additional Homelink buttons to open other garage doors, repeat step two.

How do you program a key fob for a 2007 Jeep Grand Cherokee?

2007 Jeep Grand Cherokee Remote Programming

1. Insert first programmed key into the ignition and turn ignition switch to ON.
2. Within 15 seconds of removing first key insert second programmed key into ignition and turn ignition switch to ON.
3. Within 50 seconds insert the new unprogrammed key into ignition.

How do you program a key fob for a 2006 Jeep Grand Cherokee?

2006 Jeep Grand Cherokee Remote Programming

1. Insert first programmed key into the ignition and turn ignition switch to ON.
2. Within 15 seconds of removing first key insert second programmed key into ignition and turn ignition switch to ON.
3. Within 50 seconds insert the new unprogrammed key into ignition.

How do you reset the key fob on a 2006 Jeep Grand Cherokee?

Turn the ignition switch to the ON/RUN position for at least three seconds, but no longer than 15 seconds. Then, Turn the ignition switch to the LOCK position and remove the first key.