How do I start my car if the key is not detected?

How do I start my car if the key is not detected?

If your keyless entry works with a START button and there’s no mechanical key slot, there’s still a way to start the car. Use the key fob to push the START button. Some manufacturers have a backup system that allows this method to work if the key fob battery is dead.

Why does my expedition say no key detected?

When the key fob battery is low or dead it will not have the strength to communicate with the body control module in your SUV and that will give you the no key detected error. If you still have the error message after changing the battery then that is a sign that there is a problem with your body control module.

How do you reset the anti theft system on a Ford Expedition?

To reset the anti-theft, get inside the car and insert the key. Start the car and leave it on for 15 minutes, until You see the flashing light speed come to normal. If this doesnt work, then pop the hood and disconnect the battery for fifteen minutes and the anti-theft will be reset.

How do you bypass the anti theft system on a Ford Expedition?

How to Reset the Theft Protection in a Ford Expedition

  1. Get into the Expedition and insert the known correct key into the ignition and turn it.
  2. Verify you have the right key.
  3. Wait 15 minutes, until you see the flashing rate on the red light on your dashboard decrease to normal speed and then try both keys again.

How do you bypass the Pats system on a Ford Expedition?

You can disable PATS by turning your key to the on position and holding the button the box in until it’s disabled. Cycle a key in ignition to RUN.

How do I fix PASSLock on GM?

How to Reset the Passlock System on GM Cars

  1. Insert your key in the starter, start you car as you usually would and let it stall. Keep the key in the “On” position.
  2. Wait until the “Theft Sys” light on your dashboard stays on without blinking. This will take approximately 10 to 15 minutes.

How do I relearn PASSLock?

To perform a relearn on a Passlock system, make sure there is a fully charged battery in the vehicle. The battery will be used for 30 minutes without the alternator available for charging. Connect a battery charger to the battery to ensure power is available while programming.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top