How do you remove AU Falcon tail light?

To remove the taillights:

Open boot.
Undo 2 screws holding light in.
From inside boot, undo plastic clip and loosen the boot lining covering the back part of the taillight.
Undo the 10mm nut.
Pull the tail light out.
Installation is the reverse of removal.

How do I change my tail light?

How To Replace a Tail Light

Step 1: Open trunk or tailgate.
Step 2: Pull tail lamp assembly out (if needed)
Step 3: Pull bulb out.
Step 4: Add bulb grease, put new bulb in.
Step 5: Reattach assembly (if needed)
Step 6: Repeat on other side.

How do you remove a headlight from a Ford Territory?

How to change a headlight bulb

Remove plastic cover on rear of headlamp by pushing down on long wire clip.
Pull cover outwards and downwards to release the two clips on top of cover.
Remove wiring connection from rear of bulb.
You will now find that a mirror and torch will come in handy.

How do you remove a Ford Territory rear bumper?

Look into each rear wheel well rearward and you will find a T20 torx screw on both sides, remove these. On the top of the rear bumper, between the bumper and the bottom of the liftgate opening you will find 6 to 8 plastic rivets that can be removed by pulling the center pins out, remove these.

How do I remove a FG Ute rear bumper?

Rear Bumper: Service and Repair REAR BUMPER Removal and Installation REMOVAL

Remove the LH and RH rear combination lamps.
Remove both the rear wheels and tires.
Remove the LH and RH splash shields.
Remove the rear bumper fascia clips and screws, then remove the rear bumper fascia.
Remove the rear energy absorbing foam.

How far should you be able to see with low beams?

our low beam headlights will allow you to spot an object on the road about 160 feet ahead of your vehicle. Most drivers need about 1.5 seconds to react. You might be able to swerve and miss an object or person on the road, but you might not. If you are driving too fast, the consequences could be deadly!