How do you reset the ABS light on a 2003 Dodge Ram?

How do you reset the ABS light on a 2003 Dodge Ram?

You can reset this light by disconnecting the battery.

1. Open the hood on your Dodge Ram and prop it up with the hood prop.
2. Loosen the nut on the clamp of the negative battery cable using the socket wrench.
3. Remove the negative battery cable from the battery terminal by sliding it up and off the battery.

How do you reset abs light without scan tool?

How to Reset ABS Light Without a Scan Tool (Hard Reset)

1. Get a Jumper Wire. First off, go out and buy a jumper wire.
2. Locate the DLC. Once you have the fused jumper wire or service connector adapter kit, you can find the DLC connectors.
3. Connect the Jumper to the DLC.
4. Reset the ABS System.

Why is my ABS light on in my Dodge truck?

The ABS light being on could mean that there is a problem with the ABS system. This article applies to the Dodge Ram (1994-present). The ABS (Anti-lock Brake System) light should only come on when you turn your key to “On” as a way to check that the light works or when the ABS system is activated.

Can Low brake fluid cause ABS light to come on?

One reason your vehicle’s ABS light is on is because it may be sensing abnormally low levels of brake fluid. You’ll be able to notice if your brake fluid is low by the way your car brakes. However, if the brake fluid is low, you’ll probably see more than just the ABS light come one.

Can low battery cause ABS light to come on?

Problem Description A weak battery can cause the ABS light to turn on. A brake light that is not working or has burned out can also cause the ABS light to illuminate.

Why would ABS and brake light come on?

Four Reasons Your Anti-lock Brake System Light Can Come On The four common reasons that typically cause this light to turn on include a malfunctioning ABS module, low levels in the fluid reservoir, broken wheel speed sensors, or the system is turned off.

Is it safe to drive with ABS and brake light on?

If both the ABS and brake system light come on at the same time, your vehicle is no longer safe to drive. This means there is a serious problem with the braking system, and continuing to drive puts yourself and others at risk of a car crash. This is completely normal and it means the ABS system is working normally.

How much does it cost to replace a ABS sensor?

ABS wheel sensors cost anywhere from $100 to $200 each, while ABS control modules run from $200 up to $600 apiece. In addition, expect to pay between $80 and $150 per hour for labor and anticipate at least an hour to an hour and a half of work.

What is the difference between speed sensor and ABS sensor?

The anti-lock braking system is designed to apply smooth application of brake fluid to engage the brake calipers and pads to slow your car without locking up the tires. The wheel speed sensor is responsible for relaying the wheel speed to the ECU so that it can tell the ABS system how much pressure to safely apply.