How do you test a pet wireless fence?

How do you test a pet wireless fence?

If you wish to test the battery:

1. Remove your pet’s receiver collar from your pet.
2. Take the collar to the boundary area of your containment system and listen for the collar to beep.
3. If the collar beeps or the test light tool illuminates, the battery and collar are working.

How do I increase the shock on my PetSafe collar?

Increase the Static Correction Level by pressing and releasing the Correction Level Button within 5 seconds of the previous flashes. The Static Correction Levels increase from 1 to 5. Pushing the Correction Level Button while the Receiver Collar is on level 5 will cause the Receiver Collar to revert to level 1.

How do you activate a petsafe collar?

Turning the Receiver Collar ON

1. Press and hold the Mode Button continuously for 2 seconds.
2. The green light will light up briefly and you will hear two tones chime.
3. When the Receiver Collar is turned on without a programmed boundary, the Receiver Collar will perform the ReadyTest® sequence, two chimes and then shut down.

How come my shock collar is not working?

Make sure your battery is charged in both the collar and the transmitter. Low battery charge can make for inconsistent functioning. Make sure both pieces are turned on and that the unit is properly synced so that the collar is receiving a signal from the transmitter.

How do you reset a shock collar?

Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5 times. You may need to hold both units 2-3 feet from each other before this occurs. Once the Receiver Indicator Light has flashed 5 times, the Collar Receiver has been reset and will begin flashing as normal.

How do you test a shock collar?

Using the Test Light Tool

1. Turn the Collar Receiver on.
2. Hold the Test Light Contacts to the Contact Points.
3. Press a Stimulation Button on the Remote Transmitter.
4. The Test Light will flash.
5. NOTE: At higher stimulation levels, the Test Light will flash brighter.
6. Turn the Collar Receiver off.

How bad does a shock collar hurt?

Modern shock collars do not cause pain. It is a mild tingle, a tickle. It is very much like a tens machine used by physiotherapists to heal people. Like the wee little pop of carpet static, the reaction is startle and not pain.

Can I try a shock collar on myself?

Test the Collar on Yourself This is controversial, but if done correctly like with your dog, it’s completely safe. The easiest and safest route to testing the collar’s shock stimulation on yourself, is by simply placing your hand, arm or finger across BOTH contact points.