Should you record drums with compression?

Should you record drums with compression?

This is especially important with drums, which can have extremely sharp peaks on hits. Proper use of compression will let you clamp down on the tracks without crushing them, and also let you shape the snap, crack, and sustain you want in your drums.

Should drums be compressed?

Compression can be tricky, but it’s one of the keys to achieving a modern drum sound. It’s common to apply between 3-6 dB of gain reduction to the kick and snare. Toms sometimes get compressed as well, but it depends on how often they’re used in a song.

Should you put compression on every track?

It’s necessary to add compressors on each track to change the dynamics of the tracks. Generally you should record and mix at appropriate levels so that you don’t need to do any peak reduction to prevent distortion. Compressors give us control over the dynamics of a track.

Should you compress guitars?

Generally, electric guitar sounds are pretty compressed. You don’t need additional compression when you track the guitar unless you use a clean (undistorted) setting on your guitar. If you want to use a little compression to bring the guitar forward and give it some punch, try these settings: Threshold: –1dB.

How much compression should I use on vocals?

A good starting point for a rock vocal would be a 4:1 ratio with a medium-fast attack and a medium release. Then, set the threshold for around 4 to 6dB of gain reduction. Increase or decrease the attack time until you get the right level of forwardness for the mix.

Do rappers double their vocals?

Rappers and singers have traditionally recorded vocal doubles (informally called “vocal dubs”) on the ending phrases every bar or half a bar..

Should you compress live vocals?

Remember, though that the shortest signal path with the least amount of processing will sound the most natural. Inserting a small amount of compression can help tidy up some of the more extreme dynamics of the vocal performance. I typically don’t use compression ratios high than 3:1 or so for a vocal.

How can I make my voice sound thicker?

Once you apply these ten techniques, your mixes as a whole will improve.

1. Top-End Boost.
2. Use a De’Esser.
3. Remove Resonances.
4. Control the Dynamics with Automation.
5. Catch the Peaks with a Limiter.
6. Use Multiband Compression.
7. Enhance the Highs with Saturation.
8. Use Delays Instead of Reverb.

What is the best effect for vocal?

1. Reverb. The holy grail of vocal effects, reverb is used on just about all vocal tracks to create a sense of space.

Why do my vocals sound bad?

If your vocals are recorded in a bad room, it’s extremely obvious by the end of the mix. The room that an instrument is recorded in always changes the tone. This is ESPECIALLY true for vocals. Room reflections can also cause compression and pitch correction to sound unnatural.

Why does my voice sound beautiful when I sing but when recorded it sounds horrible?

Sound travels through bone and tissue differently and even a fraction of a micro-second slower than in air. So what you hear in the recording, is free of the reverb and resonance that you hear while singing. It’s because when you speak you hear your own voice in two different ways.

How do you fix badly recorded vocals?

11 Easy Ways To Fix Poorly Recorded Tracks

1. Clipping & Distortion: iZotope RX De-clip.
2. Too Close To The Mic: Multiband Compression.
3. Over-Compressed Tracks: Upwards Expansion.
4. Harsh Tracks: EQ or Multiband Compression.
5. Snaps, Crackles, & Pops: iZotope RX.
6. Hi-Hat In The Snare Track: Sample Augmentation.

What makes a mix sound good?

Every sound should have it’s own space, so keep the important tracks (kick, snare, vocals, etc.) in the centre and pan all the other tracks out of the way by varying amounts. Reverbs and delays can be used to add a sense of depth to a sound when used wisely, but be subtle.

Can you fix peaked audio?

To sum it up for you: The best ways of refurbishing a clipped recording through editing are using equalization and applying compression. There are also a few good De-Clippers in audio repair software out there. This will usually help to make your clipped track sound at least a little more natural.