What size is the axle nut on a 2005 Grand Prix?

What size is the axle nut on a 2005 Grand Prix?

Beleive its actually 34mm, but most people including myself, have gotten away with using 36mm.

How many foot pounds is axle nut?

Also, in almost all cases, use a new axle nut. with no more than 15 to 20 ft. lbs. of torque while rotating the wheel to make sure the bearings are seated.

What size is the axle nut on a Dana 30?

Measure the nut, it’s 2 1/16″.

What size is the axle nut on a 99 Jeep Cherokee?

36mm

What size is a Jeep axle nut?

35mm is the nut size, they say 36mm will work. X2 35mm is a tight fit sometimes, but a gently tap seats the socket. A 36 mm fits a little loose, but if it’s a six sided socket it is perfectly fine.

What size is the axle nut on a 2000 Jeep Cherokee?

Registered. No, the axle nut is a 6 point 36mm. The hub bolts use a 12 point 13mm.

What front axle is in my Jeep XJ?

XJ’s all have a Dana 30 axle in the front.

What jeeps came with Dana 44 axles?

• 1967–1973 Jeepster Commando and Commando.
• 1974–1991 Wagoneer (Passenger side 1974-1979, Driver side 1980-1991)
• 1974–1983 SJ.
• 2003–2006 TJ Wrangler Rubicon (Front and rear)
• 2007-2018 JK Wrangler Rubicon (Front and rear)
• 2018-2019 JL Wrangler Rubicon (Front and rear)
• 2020 JT Gladiator (Front and rear)

Are Dana 30 axles good?

The 30 has been proven as a good little axle as long as the tires stay under 36″ or so. Like I said, I run 35’s, 4.88’s, full locker and the stroker and I beat the piss out of it and have had almost no problems with it.

How do I know what Dana 30 axle I have?

Dana 30 Axle Identification A Dana 30 cover will look like a rounded square. It should have 10 bolt holes and is 9 inches wide.

Can a Dana 30 handle 35s?

Yes. A Dana30 with 30-spline shafts will be fine for 35″ tires.

Is Dana 44 better than Dana 35?

It may not sound like a big difference, but it’s actually a pretty big. Although the Dana 44 has a larger differential, and stronger axle shafts, it shares the same weak axle tubes with the Dana 35. You could always truss the axle to make it stronger, but at the end of the day, it’ll still have really weeks tubes.

Why are Dana 35 a weak axle?

Most probably this is because the axle tube is bent and putting too much stress on the axle shaft itself, that will break any shaft over time no matter what the housing. You have to wonder what somone is doing to bend a tube! the TJ D44 had the same tubes, keep that in mind if planning an upgrade.

Is Dana 35 limited slip?

It’s a 35 and yes , you could get them with “Tracloc” (limited slip) aka “PosiTraction” from the factory , but that photo is not of an open diff . One can plainly see the carrier is as large on one side as it is on the other .