Where is the oil drain plug on a gator?

Where is the oil drain plug on a gator?

Work from the passenger side of the vehicle. Locate the drain plug on the lower-rear of the engine. Insert your 3/4-inch combination wrench through a slot in the rock guard on the bottom of the engine; a typical socket wrench is too large to fit through this slot.

Does a John Deere Gator have an oil filter?

John Deere has never offered an oil filter as factory standard equipment on the 4×2 Gator vehicles. Get piece of mind about the cleanliness of your oil in your engine. You simply remove a small cover on the engine, bolt the filter assembly in place of the cover and you are done.

What type of oil does my John Deere Gator use?

The preferred engine oil for use in the 4 x 2 Trail Gator is John Deere Plus-4 SAE 10W-40 when anticipated operating temperatures are above 4 F. For operation in temperatures to -22 F, the preferred engine oil is John Deere Torq-Gard Supreme SAE 5W-30.

How often should I service my John Deere Gator?

Do-it-yourself annual mower maintenance made easy. All the exact parts you need to ensure your Gator keeps running efficiently. Annual maintenance is highly recommended.

How many hours will a John Deere Gator last?

It has ~600 hrs on it. Oil, filter, air filter changed every 50 hours. Plugs changed every 100.

How many quarts of oil does a John Deere Gator hold?

Fluid Capacities The 4 x 2 Trail Gator holds 1.67 quarts of engine oil and 4.8 quarts of transaxle oil. How much does a John Deere Gator 6×4 weight?

Where is the fuel filter on a John Deere Gator?

How to Change the Fuel Filter on a John Deere 620i Gator

1. Locate the fuel filter on the frame under the vehicle — it can be reached without raising the vehicle.
2. Disconnect the fuel filter by depressing the white tangs on either side of the filter, then pull the fuel line off.

Does a John Deere 445 have a fuel filter?

You might not give your fuel filter any thought until your John Deere 445 riding lawnmower stops performing well. The fuel filter is a cheap and easy thing to replace as you diagnose those engine problems.

How do you reset the service light on a John Deere lawn mower?

Turn the ignition key to the “Run” position, but do not start the engine. Leave the key in this position for two hours, then turn the ignition key to the “Stop” position and remove the key. The service timer will reset and come on when the next service interval is reached.